SGBAU SY Electrical syllabus

SGBAU · Second Year B.E. Electrical Engineering · NEP 2020

Electronics Components & Circuits

3EE200PC · Semester III · 3 credits · IE 40 + ESE 60

  1. Unit 1: P-N Junction Diode Theory

    Energy bands in intrinsic and extrinsic silicon; carrier transport, diffusion and drift currents, mobility and resistivity; the PN junction and Zener diodes; the Zener voltage regulator with line and load regulation.

    Examined in the 60-mark end-semester paper

    • Energy bands and semiconductors
    • Drift and diffusion
    • PN junction and Zener diodes
    • Zener diode voltage regulator
  2. Unit 2: Rectifiers, Filters and Wave Shaping

    Half-wave, full-wave centre-tapped and bridge rectifiers; C and LC filters and their analysis; clipping and clamping circuits.

    Examined in the 60-mark end-semester paper

    • Rectifiers, filters and ripple factor
    • Clippers, clampers and RC wave-shaping circuits
  3. Unit 3: Bipolar Junction Transistor and UJT

    Theory and analysis of the BJT; biasing methods and their need, Q-point and stability factors; UJT characteristics and working.

    Examined in the 60-mark end-semester paper

    • BJT characteristics
    • BJT biasing, Q-point and bias stability
    • Crystal and UJT relaxation oscillators
  4. Unit 4: Transistor Amplifier Circuits

    Emitter follower, Darlington and bootstrap emitter followers; RC-coupled, transformer-coupled, cascaded and direct-coupled amplifiers; the cascode stage.

    Examined in the 60-mark end-semester paper

    • Emitter follower, Darlington and bootstrap circuits
    • Classification of amplifiers and coupling methods
    • Frequency response of a CE amplifier
  5. Unit 5: Special-Purpose Diodes

    Theory, construction and applications of Schottky, tunnel, varactor and selenium diodes, LEDs, photodiodes, PIN diodes and phototransistors.

    Examined in the 60-mark end-semester paper

    • PIN, tunnel and Schottky diodes
    • LEDs and opto-isolators
    • Light sensors and optical isolators
  6. Unit 6: Introduction to Linear ICs

    The operational amplifier: block schematic and internal circuits, the IC 741; inverting and non-inverting amplifiers, voltage follower, integrator and differentiator.

    Examined in the 60-mark end-semester paper

    • Op-amp characteristics
    • Inverting and non-inverting amplifiers
    • Op-amp integrator, differentiator and precision rectifier

Unit contents are summarised from the official SGBAU syllabus . AiCanCode.org is not affiliated with Sant Gadge Baba Amravati University (SGBAU).