RTMNU TY E&TC syllabus

RTMNU · Third Year B.Tech Electronics & Telecommunication Engineering · NEP 2020

Linear Electronic Circuit

BET6T22 · Semester VI · 3 credits · College 30 + university 70

  1. Unit 1: Introduction to the Operational Amplifier

    7 hours

    The op-amp block diagram, transistor differential amplifiers, op-amp parameters, virtual ground, the ideal op-amp and its equivalent circuit, the voltage transfer curve, and inverting and non-inverting configurations.

    Examined in the 70-mark end-semester paper

    • Op-amp block diagram and ideal characteristics
    • MOSFET differential amplifier and CMRR
    • Op-amp parameters: DC and AC
    • Difference amplifier, virtual short and negative feedback
    • Inverting and non-inverting amplifiers
  2. Unit 2: Op-Amp Linear Applications

    7 hours

    Voltage follower, summing, scaling and averaging amplifiers, the instrumentation amplifier, integrators and differentiators, current-to-voltage and voltage-to-current converters, peak detectors, log and antilog amplifiers and analog multipliers.

    Examined in the 70-mark end-semester paper

    • Voltage follower, summing and differential amplifiers
    • Instrumentation amplifier
    • Practical integrator and differentiator
    • V-F, I-V and V-I converters
    • Peak detectors and analog multipliers
    • Logarithmic and antilog amplifiers
  3. Unit 3: Op-Amp Non-Linear Applications

    7 hours

    Comparators, the Schmitt trigger and precision rectifiers; bistable, monostable and astable multivibrators with op-amps; sample-and-hold circuits, the 555 timer and phase-locked loops.

    Examined in the 70-mark end-semester paper

    • Comparators and the Schmitt trigger
    • Precision half-wave and full-wave rectifiers
    • Square and triangular wave generators
    • Sample-and-hold circuits
    • IC 555 timer
    • Astable and monostable multivibrators using IC 555
    • Phase-locked loop and its applications
  4. Unit 4: Design of DC Power Supply

    7 hours

    Unregulated supplies with rectifiers and filters, series voltage regulators, 78xx and 79xx IC regulators, regulator protection circuits, and buck and boost SMPS.

    Examined in the 70-mark end-semester paper

    • Rectifier and filter circuits: ripple factor, PIV and TUF
    • Series and shunt transistor voltage regulators
    • Power supply block diagram and three-terminal regulators
    • Current boosting and low-dropout regulators
    • SMPS: buck and boost converters
  5. Unit 5: Sinusoidal Oscillators and Active Filters

    8 hours

    Op-amp Wien-bridge and phase-shift oscillators, transistor Hartley and Colpitts oscillators, crystal oscillators and their figures of merit; Butterworth active low-pass, high-pass, band-pass and band-reject filters.

    Examined in the 70-mark end-semester paper

    • Barkhausen criterion and types of oscillators
    • Wien bridge oscillator
    • RC phase-shift oscillator
    • Hartley and Colpitts oscillators
    • Crystal oscillator
    • First and second-order active filters

Unit contents are summarised from the official RTMNU syllabus . AiCanCode.org is not affiliated with Rashtrasant Tukadoji Maharaj Nagpur University (RTMNU).