RTMNU TY E&TC syllabus

RTMNU · Third Year B.Tech Electronics & Telecommunication Engineering · NEP 2020

Embedded System Design

BET5T15 · Semester V · 3 credits · College 30 + university 70

  1. Unit 1: The Concept of Embedded Systems Design

    8 hours

    History, definition and classification of embedded systems, design metrics and their optimisation, design challenges and processor selection; the building blocks of a typical embedded system (cores, memory, sensors, actuators and interfaces), design trade-offs and recent trends.

    Examined in the 70-mark end-semester paper

    • Embedded systems: classification and characteristics
    • Design metrics and optimisation
    • Microcontroller, microprocessor and SoC
    • Selecting a microcontroller
    • Hardware–software co-design and the design life cycle
    • Sensor and actuator interfacing
  2. Unit 2: Technological Aspects and Embedded Microcontroller Cores

    7 hours

    The interrupt service mechanism, context switching and device drivers; the ARM7TDMI's pins, block diagram, core and interrupt structure, programming model, operating modes, exceptions and interrupt handling.

    Examined in the 70-mark end-semester paper

    • Context switching and priority inversion
    • Kernel configuration and device drivers
    • ARM7 architecture, operating modes and pipeline
    • ARM core data flow and programmer's model
    • ARM operating modes, registers, CPSR and SPSR
    • ARM7 pipeline and exceptions
    • LPC2148 interrupt structure
  3. Unit 3: Interfacing with External Systems

    The ARM7TDMI instruction set and programming in assembly and Embedded C; interfacing LEDs, seven-segment displays, switches, a multiplexed keyboard and a stepper motor; the ARM7TDMI's timers and counters.

    Examined in the 70-mark end-semester paper

    • ARM and Thumb instruction sets
    • ARM instruction set
    • LPC2148 GPIO programming: LED, keypad and GLCD
    • Interfacing seven-segment displays and stepper motors with the LPC2148
    • LPC2148 timers and match registers
  4. Unit 4: Interfacing Analog and Digital Blocks

    The ARM7TDMI's built-in ADC and DAC, PWM applications, a temperature sensor, USART, Bluetooth, USB drive, I2C, LCD and GLCD, GSM and GPS modules, an SD card over SPI, and waveform generation with the on-chip DAC.

    Examined in the 70-mark end-semester paper

    • ADC and DAC on the LPC2148
    • PWM on the LPC2148
    • UART programming on the LPC2148
    • LPC2148 timers, watchdog, UART and I2C
    • Interfacing GLCD, SD card and sensors with ARM
    • GSM and GPS module interfacing
    • I2C EEPROM and SPI SD card interfacing
  5. Unit 5: Embedded System Design Case Studies

    The processor design approach to an embedded system: PowerPC-based design, MicroBlaze-based design on Xilinx and Nios II-based design on Altera, with each processor's architecture taken into account.

    Examined in the 70-mark end-semester paper

    • Processor-based embedded design: the PowerPC
    • Soft-core processors: MicroBlaze on Xilinx and Nios II on Altera

Unit contents are summarised from the official RTMNU syllabus . AiCanCode.org is not affiliated with Rashtrasant Tukadoji Maharaj Nagpur University (RTMNU).