RTMNU TY E&TC syllabus

RTMNU · Third Year B.Tech Electronics & Telecommunication Engineering · NEP 2020

CMOS VLSI Design

BET5T18-2 · Elective I · Semester V · 3 credits · College 30 + university 70

One of the Elective I options.

  1. Unit 1: Introduction to the MOSFET

    7 hours

    CMOS fabrication steps; NMOS and PMOS enhancement transistors and their regions of operation; threshold voltage, MOS device equations and small-signal models.

    Examined in the 70-mark end-semester paper

    • CMOS fabrication: photolithography, diffusion, ion implantation and the twin-tub process
    • MOSFET operation and long-channel I–V characteristics
    • MOSFET second-order effects
    • MOSFET small-signal equivalent circuit and parameters
  2. Unit 2: Logic Design with MOSFETs

    7 hours

    MOSFETs as ideal switches and Boolean operations; basic and compound CMOS gates, transmission-gate circuits and pass transistors.

    Examined in the 70-mark end-semester paper

    • MOSFET as a switch and the CMOS inverter
    • CMOS NAND and NOR gates
    • CMOS combinational logic design
    • Latch-up and transmission gates
  3. Unit 3: MOS Inverter Characteristics

    7 hours

    Resistive-load and nMOS-load inverters; the CMOS inverter, its operation and DC characteristics, the tristate inverter, noise margin, and the BiCMOS inverter.

    Examined in the 70-mark end-semester paper

    • Resistive-load and nMOS-load inverters
    • CMOS inverter characteristics
    • Noise margins and the beta ratio
    • Tristate and BiCMOS inverters
  4. Unit 4: Combinational Circuit Design

    8 hours

    Static CMOS and ratioed logic; device capacitance, switching characteristics, rise, fall and propagation delays, power dissipation, charge sharing, fan-in and fan-out; complementary, pseudo-NMOS, dynamic and pass-transistor logic.

    Examined in the 70-mark end-semester paper

    • MOS capacitance models and C–V characteristics
    • CMOS delay and power dissipation
    • Power dissipation and power-delay product
    • Ratioed logic and pseudo-NMOS gates
    • Charge sharing, fan-in and fan-out
    • Pass-transistor and dynamic CMOS logic: domino and zipper
  5. Unit 5: Sequential Circuits and Datapath Components

    7 hours

    Latches and flip-flops and advanced CMOS techniques; datapath design with comparators, barrel shifters, multiplexers, decoders, equality detectors, priority encoders, shifters, adders and multipliers.

    Examined in the 70-mark end-semester paper

    • Static and dynamic latches, flip-flops and registers
    • Datapath components: comparators, shifters, decoders and encoders
    • Adders and multipliers: ripple-carry and carry-look-ahead

Unit contents are summarised from the official RTMNU syllabus . AiCanCode.org is not affiliated with Rashtrasant Tukadoji Maharaj Nagpur University (RTMNU).