RTMNU TY Electrical syllabus

RTMNU · Third Year B.Tech Electrical Engineering · NEP 2020

Power Systems-II

BEL5T15 · Semester V · 3 credits · College 30 + university 70

The PDF heads Unit II "Unit I" and prints no hours for it.

  1. Unit 1: Symmetrical Component Transformation

    8 hours

    Three-phase power in unbalanced circuits in terms of symmetrical components; sequence impedances of generators, transformers, transmission lines and passive loads; phase shift in star-delta three-phase transformers.

    Examined in the 70-mark end-semester paper

    • Symmetrical components
    • Sequence impedances and sequence networks
    • Phase shift of sequence components in star-delta transformers
  2. Unit 2: Symmetrical and Unsymmetrical Fault Analysis

    Symmetrical fault analysis with and without pre-fault load current; L-G, L-L-G, L-L and open-conductor faults by symmetrical components; selection of circuit-breaker ratings and current-limiting reactors.

    Examined in the 70-mark end-semester paper

    • Symmetrical fault calculation and short-circuit MVA
    • Single line-to-ground fault
    • Line-to-line fault
    • Double line-to-ground fault
    • Open conductor faults
    • Selection of circuit breakers
    • Current-limiting reactors
  3. Unit 3: Stability of Power Systems

    10 hours

    Steady-state, dynamic and transient stability; dynamics of the synchronous machine and the swing equation for machines swinging coherently and non-coherently; the power-angle equation and steady-state stability; swing curves, the equal area criterion and its application to different disturbances, point-by-point solution of the swing equation, and methods of improving transient stability.

    Examined in the 70-mark end-semester paper

    • Swing equation
    • Steady state, transient and dynamic stability
    • Power angle curve
    • Equal area criterion
    • Step-by-step solution of the swing equation
    • Methods to improve stability
  4. Unit 4: Economic Operation of Power Systems

    8 hours

    Distribution of load between units within a plant; optimum generation scheduling with transmission losses; representing transmission loss by the loss-formula coefficients, their derivation, and solving the coordination equation on a computer.

    Examined in the 70-mark end-semester paper

    • Economic load division between units in a plant
    • Economic load dispatch and unit commitment
    • Economic dispatch by Lagrange multipliers
    • Penalty factor and B-coefficients
  5. Unit 5: Power System Dynamics

    8 hours

    Turbines and speed governors, frequency dependence of loads, droop control and power sharing; automatic generation control; generation and absorption of reactive power by power-system components; excitation control of synchronous generators and automatic voltage regulators.

    Examined in the 70-mark end-semester paper

    • Speed governing and turbine models
    • Load frequency control of an isolated system
    • Automatic generation control
    • Production and absorption of reactive power
    • Types of excitation systems
    • Automatic voltage regulator

Unit contents are summarised from the official RTMNU syllabus . AiCanCode.org is not affiliated with Rashtrasant Tukadoji Maharaj Nagpur University (RTMNU).