RTMNU SY E&TC syllabus

RTMNU · Second Year B.Tech Electronics & Telecommunication Engineering · NEP 2020

Electronics Devices and Circuits

BET3T09 · Semester III · 3 credits · College 30 + university 70

  1. Unit 1: Bipolar Junction Transistors

    7 hours

    The BJT's physical structure and operating modes, active-region operation and DC analysis of transistor circuits, the Ebers–Moll model, CE, CB and CC characteristics, and the transistor as an amplifier and as a switch.

    Examined in the 70-mark end-semester paper

    • BJT characteristics in CE configuration
    • BJT versus MOSFET
    • Hybrid-pi model and CE amplifier analysis
  2. Unit 2: Transistor Biasing Techniques

    8 hours

    The operating point and bias stability; fixed, collector-to-base, self and emitter-feedback bias; stabilisation against variations in ICO, VBE and β, collector-current stability and thermal runaway.

    Examined in the 70-mark end-semester paper

    • DC load line, Q-point and BJT biasing
    • BJT characteristics in CE configuration
  3. Unit 3: MOSFET and Biasing Techniques

    7 hours

    The JFET, pinch-off voltage and volt-ampere characteristics; MOSFET characteristics and the small-signal equivalent model; common-source, common-drain and common-gate MOSFET amplifiers.

    Examined in the 70-mark end-semester paper

    • JFET characteristics and parameters
    • JFET amplifiers and biasing
    • Enhancement MOSFET: structure and characteristics
    • MOSFET biasing and the DC load line
    • MOSFET small-signal equivalent circuit and parameters
    • Common-source amplifier and its AC analysis
    • Source follower
  4. Unit 4: Feedback Amplifiers and Oscillators

    7 hours

    The general feedback structure, properties of negative and positive feedback and the four basic feedback topologies; RC phase-shift, Wien bridge and crystal oscillators.

    Examined in the 70-mark end-semester paper

    • Feedback topologies and their effects
    • Voltage-series and current-series feedback amplifiers
    • Barkhausen criterion and types of oscillators
    • RC phase-shift oscillator
    • Wien bridge oscillator
    • Crystal oscillator
  5. Unit 5: Power Amplifier

    7 hours

    Class A, B, AB, C and D amplifiers, power efficiency and dissipation, cross-over distortion in class AB circuits, the transformer-coupled class A amplifier, and harmonic distortion under large-signal operation.

    Examined in the 70-mark end-semester paper

    • Classification of power amplifiers
    • Transformer-coupled class A amplifier
    • Class B push-pull and complementary symmetry amplifiers
    • Efficiency and power dissipation of power amplifiers

Unit contents are summarised from the official RTMNU syllabus . AiCanCode.org is not affiliated with Rashtrasant Tukadoji Maharaj Nagpur University (RTMNU).