RTMNU SY E&TC syllabus

RTMNU · Second Year B.Tech Electronics & Telecommunication Engineering · NEP 2020

Digital System Design with HDL

BET3T10 · Semester III · 3 credits · College 30 + university 70

  1. Unit 1: Digital Design Fundamentals

    8 hours

    Combinational and sequential design issues, finite state machines and Moore and Mealy machines; programmable devices (PLA, PAL, PROM), the structure of CPLDs, and FPGA architecture with CLBs, IOBs, programmable interconnect points and the types of programmable switch.

    Examined in the 70-mark end-semester paper

    • Moore and Mealy machines
    • PROM, PAL and PLA
    • CPLD and FPGA architecture
    • CLBs, LUTs, IOBs and interconnect
    • Programmable switch technologies: SRAM, antifuse and EEPROM
  2. Unit 2: HDL Design Methodologies

    7 hours

    What an HDL must provide, design methodologies and modelling styles; an introduction to Verilog, its elements, and the module definition and its parts.

    Examined in the 70-mark end-semester paper

    • Verilog design flow and methodology
    • Levels of abstraction in Verilog
    • Verilog modules, ports and instantiation
  3. Unit 3: Introduction to Verilog

    8 hours

    Keywords, syntax and semantics, comments, identifiers and number representation; ports, data types, wires and variables, constants and parameters, operators; design entry, test benches, compilation, synthesis and timing analysis.

    Examined in the 70-mark end-semester paper

    • Verilog data types and number representation
    • Verilog operators
    • Simulation, synthesis and test benches
    • Setup time, hold time and propagation delay
  4. Unit 4: Data Flow Modeling

    6 hours

    Delays and continuous and delayed continuous assignment; structural modelling and module instantiation; gate-level primitives and gate delays, switch-level primitives and user-defined primitives.

    Examined in the 70-mark end-semester paper

    • Dataflow modelling and continuous assignment
    • Gate-level modelling and delays
    • Hierarchical modelling examples
    • Switch-level modelling and user-defined primitives
  5. Unit 5: Behavioral Modeling

    7 hours

    Initial and always blocks, procedural, blocking and non-blocking assignments, sequential and parallel blocks, race conditions; timing, event-based and zero-delay control, conditional and loop statements, compiler directives, assign–deassign and force–release; latch, flip-flop and state machine coding with Moore and Mealy machines.

    Examined in the 70-mark end-semester paper

    • Behavioural modelling: initial and always blocks
    • Blocking and non-blocking assignments
    • if–else and case statements
    • Timing control and loop statements in Verilog
    • Procedural continuous assignments: assign–deassign and force–release
    • Compiler directives and system tasks
    • Flip-flops with synchronous and asynchronous reset
    • Moore and Mealy FSMs in Verilog

Unit contents are summarised from the official RTMNU syllabus . AiCanCode.org is not affiliated with Rashtrasant Tukadoji Maharaj Nagpur University (RTMNU).