RTMNU SY Electrical syllabus

RTMNU · Second Year B.Tech Electrical Engineering · NEP 2020

Electronic Devices and Circuits

BMD3T11 · Semester III · 2 credits · College 30 + university 70

A 2-credit multidisciplinary minor (MDM-I) course in the Electrical scheme: college assessment 30 + university exam 70 (3 hours).

  1. Unit 1: Basic Diode and Its Applications

    7 hours

    PN junction diode operation and characteristics, half-wave and full-wave rectifiers, filters and ripple factor, Zener diode characteristics and the Zener voltage regulator, and photodiodes.

    Examined in the 70-mark end-semester paper

    • PN junction and Zener diodes
    • Rectifiers, filters and ripple factor
    • Zener diode voltage regulator
    • Photodetectors and CCDs
  2. Unit 2: Basic Transistor and Its Applications

    10 hours

    BJT operation and characteristics, the BJT as a switch and an amplifier, biasing circuits, small-signal analysis and comparison of CE, CB and CC amplifiers, and the principle and characteristics of FETs and MOSFETs.

    Examined in the 70-mark end-semester paper

    • BJT characteristics
    • BJT biasing, Q-point and bias stability
    • Transistor as an amplifier and a switch
    • Small-signal analysis of single-stage amplifiers
    • JFET characteristics
    • MOSFET characteristics
  3. Unit 3: Power Amplifiers

    10 hours

    Class A, B, AB and C amplifiers, push-pull stages and crossover distortion, positive and negative feedback amplifiers, differential amplifier stages, current sources, biasing and level shifting, and oscillators: the Barkhausen criterion, RC and crystal oscillators.

    Examined in the 70-mark end-semester paper

    • Class A, B, AB and C power amplifiers
    • Push-pull and complementary-symmetry amplifiers
    • Barkhausen criterion and feedback
    • Differential amplifiers, current sources and level shifting
    • RC and LC oscillators
    • Crystal and UJT relaxation oscillators
  4. Unit 4: Applications of Op-Amp

    4 hours

    Inverting and non-inverting amplifiers, integrator, active filters, voltage regulators, Wien bridge and phase-shift oscillators, analog-to-digital conversion, hysteresis comparator, zero-crossing detector, square and triangular-wave generators, precision rectifier, and the LM741, LM555 and LM7805 ICs.

    Examined in the 70-mark end-semester paper

    • Inverting and non-inverting amplifiers
    • Op-amp integrator, differentiator and precision rectifier
    • Comparators and zero-crossing detectors
    • Op-amp waveform generators
    • First-order active low-pass and high-pass filters
    • ADC and DAC: ADC0808 and DAC0808
    • IC 555 timer
    • Voltage regulators: 78xx, 79xx and LM317

Unit contents are summarised from the official RTMNU syllabus . AiCanCode.org is not affiliated with Rashtrasant Tukadoji Maharaj Nagpur University (RTMNU).