RTMNU Final E&TC syllabus

RTMNU · Final Year B.Tech Electronics & Telecommunication Engineering · CBCS

Mixed Signal Design

BEETC702PE-T · Elective IV · Semester VII · 4 credits · College 30 + university 70

One of the Elective IV options.

  1. Unit 1: Switched-Capacitor Circuits

    6 hours

    Basic building blocks, operation and analysis of switched-capacitor circuits and their non-ideal effects; switched-capacitor integrators, first-order filters, switch sharing and biquad filters.

    Examined in the 70-mark end-semester paper

    • Switched-capacitor circuits: building blocks and operation
    • Non-ideal effects in switched-capacitor circuits
    • Switched-capacitor integrators
    • Switched-capacitor filters
  2. Unit 2: Phase-Locked Loops

    8 hours

    Basic PLL topology and dynamics; charge-pump PLLs, lock acquisition and the phase-frequency detector; non-idealities and jitter in PLLs; delay-locked loops and applications.

    Examined in the 70-mark end-semester paper

    • Phase-locked loop and its applications
    • PLL dynamics and lock acquisition
    • Charge-pump PLLs and phase-frequency detectors
    • Jitter and non-idealities in PLLs
    • Delay-locked loops
  3. Unit 3: Data Converter Fundamentals

    8 hours

    DC and dynamic specifications and quantisation noise; Nyquist-rate D/A converters — decoder-based, binary-scaled, thermometer-code and hybrid converters.

    Examined in the 70-mark end-semester paper

    • ADC and DAC specifications and comparison
    • Quantisation noise in data converters
    • Weighted-resistor and R-2R ladder DACs
    • Decoder-based, thermometer-code and hybrid DACs
  4. Unit 4: Nyquist-Rate A/D Converters

    8 hours

    Successive-approximation and flash converters; two-step, interpolating, folding, pipelined and time-interleaved A/D converters.

    Examined in the 70-mark end-semester paper

    • SAR, flash and dual-slope ADCs
    • Two-step and subranging ADCs
    • Interpolating and folding ADCs
    • Pipelined and time-interleaved ADCs
  5. Unit 5: Oversampling Converters

    6 hours

    Noise-shaping modulators, decimating and interpolating filters, higher-order modulators, delta-sigma modulators with multi-bit quantisers, and delta-sigma D/A converters.

    Examined in the 70-mark end-semester paper

    • Oversampling and noise shaping
    • Delta-sigma modulators: higher-order and multi-bit
    • Decimation and interpolation filters for oversampling converters
    • Delta-sigma DACs

Unit contents are summarised from the official RTMNU syllabus . AiCanCode.org is not affiliated with Rashtrasant Tukadoji Maharaj Nagpur University (RTMNU).