RTMNU · Final Year B.Tech Electronics & Telecommunication Engineering · CBCS
CMOS VLSI Design
BEETC801PE · Elective VI · Semester VIII · 4 credits · College 30 + university 70
One of the Elective VI options.
Unit 1: Introduction to the MOSFET
10 hoursCMOS fabrication steps; NMOS enhancement transistors and their operation and regions; threshold voltage, MOS device equations and small-signal models.
Examined in the 70-mark end-semester paper
- CMOS fabrication: photolithography, diffusion, ion implantation and the twin-tub process
- MOSFET operation and long-channel I–V characteristics
- MOSFET second-order effects
- MOSFET small-signal equivalent circuit and parameters
Unit 2: Logic Design with MOSFETs
10 hoursMOSFETs as ideal switches and Boolean operations; basic and compound CMOS gates, transmission-gate circuits and pass transistors.
Examined in the 70-mark end-semester paper
- MOSFET as a switch and the CMOS inverter
- CMOS NAND and NOR gates
- CMOS combinational logic design
- Latch-up and transmission gates
Unit 3: MOS Inverter Characteristics
9 hoursResistive-load and nMOS-load inverters; the CMOS inverter, its operation and DC characteristics, the tristate inverter, noise margin, and the BiCMOS inverter.
Examined in the 70-mark end-semester paper
- Resistive-load and nMOS-load inverters
- CMOS inverter characteristics
- Noise margins and the beta ratio
- Tristate and BiCMOS inverters
Unit 4: Combinational Circuit Design
9 hoursStatic CMOS and ratioed logic; device capacitance, switching characteristics, rise, fall and propagation delays, power dissipation, charge sharing, fan-in and fan-out; complementary, pseudo-NMOS, dynamic, domino and pass-transistor logic.
Examined in the 70-mark end-semester paper
- MOS capacitance models and C–V characteristics
- CMOS delay and power dissipation
- Power dissipation and power-delay product
- Ratioed logic and pseudo-NMOS gates
- Charge sharing, fan-in and fan-out
- Pass-transistor and dynamic CMOS logic: domino and zipper
Unit 5: Sequential Circuits and Datapath Components
10 hoursLatches and flip-flops and advanced CMOS techniques; datapath design with comparators, barrel shifters, multiplexers, decoders, equality detectors, priority encoders, shifters, adders and multipliers.
Examined in the 70-mark end-semester paper
- Static and dynamic latches, flip-flops and registers
- Datapath components: comparators, shifters, decoders and encoders
- Adders and multipliers: ripple-carry and carry-look-ahead
Unit contents are summarised from the official RTMNU syllabus . AiCanCode.org is not affiliated with Rashtrasant Tukadoji Maharaj Nagpur University (RTMNU).