RTMNU Final Electrical syllabus

RTMNU · Final Year B.Tech Electrical Engineering · CBCS

Power Semiconductor Drives

BTCHEE802T · Professional Elective VI · Semester VIII · 3 credits · College 30 + university 70

One of the Professional Elective VI options.

  1. Unit 1: Dynamics of Electric Drives

    8 hours

    Block diagram of drives, four-quadrant operation and the hoist drive, load torque and the fundamental torque equation, time and energy loss in transients, modes of operation and steady-state stability.

    Examined in the 70-mark end-semester paper

    • Electric drive components
    • Four-quadrant operation
    • Dynamics of electric drives and torque equations
    • Time and energy loss in transients
    • Load torque and steady-state stability
  2. Unit 2: DC Motor Drives

    7 hours

    Single- and three-phase fully controlled rectifier drives of separately excited motors (continuous conduction), dual converter control, fractional-hp motors and chopper-controlled drives.

    Examined in the 70-mark end-semester paper

    • Converter-fed DC drives
    • Dual converter-fed DC drives
    • Chopper-fed DC drives
  3. Unit 3: Induction Motor Drives

    7 hours

    Stator voltage control, VSI and CSI control, variable-frequency control, cycloconverter control, static rotor resistance control and the Scherbius and Kramer drives.

    Examined in the 70-mark end-semester paper

    • Stator voltage and V/f control
    • VSI and CSI fed induction motor drives
    • Cycloconverters
    • Slip power recovery and rotor resistance control
  4. Unit 4: Special Industrial Drives

    7 hours

    BLDC, stepper and switched-reluctance motor drives, solar and battery powered drives, and energy conservation in drives.

    Examined in the 70-mark end-semester paper

    • BLDC drive operation
    • Synchronous reluctance motor drives
    • Solar and battery powered drives
    • Energy conservation in motors and drives
  5. Unit 5: Traction Drives

    7 hours

    Conventional DC and AC traction, resistance control, converter-controlled drives, 25 kV AC traction with on-load tap changers or semiconductor converters, and chopper-controlled DC traction.

    Examined in the 70-mark end-semester paper

    • Traction and crane drives
    • AC traction supply and current collection
    • Traction motor control: series-parallel and multiple unit control
    • Converter-controlled 25 kV AC and chopper-controlled DC traction

Unit contents are summarised from the official RTMNU syllabus . AiCanCode.org is not affiliated with Rashtrasant Tukadoji Maharaj Nagpur University (RTMNU).