RTMNU · Final Year B.Tech Civil Engineering · CBCS
Advance Soil Engineering
BTCVE702T · Elective IV · Semester VII · 3 credits · College 30 + university 70
One of the Elective IV options.
Unit 1: Consolidation
6 hoursOne-dimensional compression and the oedometer test, coefficient of volume change, compression index, preconsolidation stress and over-consolidation ratio; primary and secondary compression, one-, two- and three-dimensional consolidation, partially saturated soils and creep.
Examined in the 70-mark end-semester paper
- Consolidation test
- Normally and over-consolidated clays
- Terzaghi's one-dimensional consolidation
- Primary and secondary consolidation
- Three-dimensional consolidation and partially saturated soils
Unit 2: Soil Strength
5 hoursThe effective stress law for saturated and partially saturated soils, pore pressure measurement, the effect of the intermediate principal stress and rate of loading, stress dilatancy, plane strain, stress paths and Hvorslev parameters.
Examined in the 70-mark end-semester paper
- Effective stress principle
- Mohr–Coulomb failure theory
- Triaxial test and drainage conditions
- Stress paths and Hvorslev parameters
Unit 3: Earth Pressure
5 hoursRankine, Coulomb and graphical methods of earth pressure; stability checks and design of gravity, cantilever and counterfort retaining walls.
Examined in the 70-mark end-semester paper
- Rankine's earth pressure theory
- Coulomb's wedge theory
- Rebhann's, Poncelet's and Culmann's graphical methods
- Stability checks for gravity retaining walls
- Design of cantilever retaining walls
- Design of counterfort retaining walls
Unit 4: Liquefaction of Soils
3 hoursThe mechanism of liquefaction, factors affecting it, liquefaction of cohesionless soils and sensitive clays, and liquefaction susceptibility.
Examined in the 70-mark end-semester paper
- Liquefaction of soils
- Factors affecting liquefaction
- Liquefaction potential from SPT
Unit 5: Machine Foundations
8 hoursTypes of machines and machine foundations, modes of vibration and design criteria; elastic half-space and lumped-parameter solutions, foundations for reciprocating and impact machines and turbines, vibration isolation and the bearing capacity of dynamically loaded foundations.
Examined in the 70-mark end-semester paper
- Design criteria for machine foundations
- Degrees of freedom of a block foundation
- Elastic half-space and lumped-parameter models
- Vertical and sliding vibration of block foundations
- Barkan's method
- Vibration isolation and screening
Unit contents are summarised from the official RTMNU syllabus . AiCanCode.org is not affiliated with Rashtrasant Tukadoji Maharaj Nagpur University (RTMNU).