PAHSU TY E&TC syllabus

PAHSU · Third Year B.Tech. Electronics and Telecommunication Engineering · NEP 2020

Electronics System Design

ENTPCC-11 · Semester VI · 3 credits · ISE 30 + ESE 70

Taught with 2 lecture hours and a 2-hour lab a week. The notes subject is Power Electronics, which carries the device, converter and chopper units; the instrumentation and controller units link topics from Sensors and Transducers, PLC and SCADA, and Control Systems.

  1. Unit 1: Modern Power Semiconductor Devices

    7 hours

    The power IGBT: construction, working, transfer and output characteristics and applications; the SCR: construction, working, V-I characteristics, turn-on and turn-off; the TRIAC and DIAC.

    Examined in the 70-mark end-semester paper

    • Power MOSFET and IGBT
    • SCR construction and characteristics
    • SCR turn-on, turn-off and gate triggering
    • GTO, TRIAC and UJT
  2. Unit 2: Power Electronics Applications

    5 hours

    Single-phase half-wave, centre-tapped full-wave and fully controlled bridge rectifiers; AC power control with the DIAC and TRIAC.

    Examined in the 70-mark end-semester paper

    • Single-phase semi-converter
    • Single-phase full converter
    • AC voltage controllers
  3. Unit 3: Chopper Circuits

    5 hours

    Types and control strategies of DC choppers; single-, two- and four-quadrant choppers; the Morgan chopper.

    Examined in the 70-mark end-semester paper

    • Step-down and step-up choppers
    • Chopper control strategies
    • Chopper classes A to E
    • Voltage-commutated and Jones choppers
  4. Unit 4: Timers, Counters and the Digital Voltmeter

    6 hours

    A timer with the XR 2240, a time and event counter with the IC 74C926, and a three-digit multi-range DVM from discrete components.

    Examined in the 70-mark end-semester paper

    • Timer, counter and digital voltmeter design
  5. Unit 5: Signal Conditioning Circuits

    6 hours

    Signal conditioning for the PT100, LM35 and J- and K-type thermocouples; the 4-20 mA current loop; zero and span circuits, offset, V-to-I, I-to-V and V-to-V converters.

    Examined in the 70-mark end-semester paper

    • Resistance temperature detectors
    • Thermocouples: laws and cold junction compensation
    • Transmitters and signal standards
    • V-F, I-V and V-I converters
    • Zero and span adjustment circuits
  6. Unit 6: Design of Controllers and PLC Applications

    5 hours

    Analog ON/OFF and proportional controllers for a process; PLC fundamentals and applications such as a bottle-filling plant and elevator control.

    Examined in the 70-mark end-semester paper

    • ON–OFF controllers
    • P, PI, PD and PID controllers
    • PLC architecture and modules
    • Ladder diagram basics

Unit contents are summarised from the official PAHSU syllabus . AiCanCode.org is not affiliated with Punyashlok Ahilyadevi Holkar Solapur University (PAHSU).