PAHSU TY Electrical syllabus

PAHSU · Third Year B.Tech. Electrical Engineering · NEP 2020

Power System Analysis

EEPCC-08 · Semester V · 4 credits · ISE 30 + ESE 70

  1. Unit 1: Representation of Power System Components

    8 hours

    Power in single- and three-phase circuits and complex power balance; equivalent circuits of synchronous machines, lines, transformers and loads; single-line, reactance and per-unit impedance diagrams; network matrices: Y-bus by inspection and singular transformation and the modified bus impedance matrix; AI in power system analysis.

    Examined in the 70-mark end-semester paper

    • Single-line and reactance diagrams
    • Per-unit system and change of base
    • Primitive network and incidence matrices
    • Formation of the Y-bus matrix
    • Z-bus matrix
  2. Unit 2: Symmetrical Faults Analysis

    5 hours

    Symmetrical faults, percentage reactance and short-circuit kVA; reactors to limit short-circuit current; selecting circuit breaker ratings; transients on a transmission line; short-circuit currents and the reactances of synchronous machines with and without load.

    Examined in the 70-mark end-semester paper

    • Short circuit of an unloaded alternator
    • Subtransient and transient reactances
    • Symmetrical fault calculation and short-circuit MVA
    • Current-limiting reactors
    • Selection of circuit breakers
  3. Unit 3: Symmetrical Components

    8 hours

    Resolving unbalanced phasors into symmetrical components; power in terms of symmetrical components; balanced and unbalanced loads on an unbalanced supply; sequence impedances and networks of alternators, transformers and lines.

    Examined in the 70-mark end-semester paper

    • Symmetrical components
    • Sequence impedances and sequence networks
  4. Unit 4: Unsymmetrical Faults

    7 hours

    L-G, L-L and L-L-G faults on an unloaded alternator and on a power system, with and without fault impedance; open-conductor faults.

    Examined in the 70-mark end-semester paper

    • Single line-to-ground fault
    • Line-to-line fault
    • Double line-to-ground fault
    • Open conductor faults
  5. Unit 5: Load Flow Studies

    8 hours

    Complex power flow and the power flow equations; bus classification, operating constraints and data; Gauss-Seidel method for PQ and PV buses and acceleration of convergence; Newton-Raphson in polar coordinates; fast decoupled load flow; comparison of methods.

    Examined in the 70-mark end-semester paper

    • Load flow equations and bus classification
    • Gauss-Seidel load flow
    • Newton-Raphson load flow
    • Decoupled and fast decoupled load flow
  6. Unit 6: Stability Studies

    6 hours

    Rotor dynamics and the swing equation; steady-state and transient stability; the equal area criterion and its applications; critical clearing angle and time.

    Examined in the 70-mark end-semester paper

    • Swing equation
    • Steady state, transient and dynamic stability
    • Equal area criterion
    • Critical clearing angle

Unit contents are summarised from the official PAHSU syllabus . AiCanCode.org is not affiliated with Punyashlok Ahilyadevi Holkar Solapur University (PAHSU).