PAHSU SY E&TC syllabus

PAHSU · Second Year B.Tech. Electronics and Telecommunication Engineering · NEP 2020

Electronics Circuit Analysis and Design

ENTPCC-02 · Semester III · 3 credits · ISE 30 + ESE 70

Unit 3 also covers the Zener diode as a voltage regulator, and Unit 1 voltage doublers and triplers; they are in the unit contents but have no notes topic of their own here.

  1. Unit 1: Diode and its Special Applications

    7 hours

    Half-wave, full-wave and bridge rectifiers with detailed analysis (rms and average output, ripple factor, efficiency, TUF, PIV); series, shunt, positive, negative and combinational clippers and their design; positive and negative clampers; voltage doubler and tripler.

    Examined in the 70-mark end-semester paper

    • Rectifier and filter circuits: ripple factor, PIV and TUF
    • Diode clippers, clampers and RC wave-shaping circuits
  2. Unit 2: Filter Circuits

    6 hours

    Capacitor, inductor, LC and π filters: analysis, comparison and design problems.

    Examined in the 70-mark end-semester paper

    • Rectifier and filter circuits: ripple factor, PIV and TUF
  3. Unit 3: Design of Unregulated Power Supply

    7 hours

    Design of an unregulated power supply with a rectifier and filter (choice of transformer, diodes and filter components); the Zener diode as a voltage regulator.

    Examined in the 70-mark end-semester paper

    • Power supply block diagram and three-terminal regulators
    • Series and shunt transistor voltage regulators
  4. Unit 4: Bipolar Junction Transistor

    7 hours

    CB, CE and CC characteristics, Early effect and punch-through; DC load line, Q-point and voltage-divider bias with its stability factor; the h-model and the BJT as an amplifier; cascading and coupling schemes; design of a single-stage RC-coupled CE amplifier.

    Examined in the 70-mark end-semester paper

    • BJT characteristics in CE configuration
    • DC load line, Q-point and BJT biasing
    • Hybrid-pi model and CE amplifier analysis
    • RC-coupled CE amplifier and its frequency response
  5. Unit 5: Feedback Amplifier

    6 hours

    Classification of amplifiers, the feedback concept and the general characteristics of negative-feedback amplifiers; feedback topologies and their analysis; effect of negative feedback on stability, bandwidth, noise, distortion and input and output resistance.

    Examined in the 70-mark end-semester paper

    • Feedback topologies and their effects
    • Voltage-series and current-series feedback amplifiers
  6. Unit 6: Field Effect Transistor

    7 hours

    JFET construction, transfer and drain characteristics, Shockley's equation, biasing and DC analysis, the JFET CS amplifier; MOSFET construction, working and V-I characteristics, the MOSFET as a switch and as a CS amplifier; introduction to CMOS.

    Examined in the 70-mark end-semester paper

    • JFET characteristics and parameters
    • JFET amplifiers and biasing
    • Enhancement MOSFET: structure and characteristics
    • Common-source amplifier and its AC analysis
    • MOSFET as a switch and the CMOS inverter

Unit contents are summarised from the official PAHSU syllabus . AiCanCode.org is not affiliated with Punyashlok Ahilyadevi Holkar Solapur University (PAHSU).