PAHSU SY E&TC syllabus

PAHSU · Second Year B.Tech. Electronics and Telecommunication Engineering · NEP 2020

Analog Integrated Circuits

ENTPCC-06 · Semester IV · 4 credits · ISE 30 + ESE 70

  1. Unit 1: Fundamentals of Operational Amplifier

    8 hours

    The dual-input balanced-output differential amplifier and its AC and DC analysis; op-amp block diagram, equivalent circuit, transfer curve and ideal and practical parameters; open-loop configurations; inverting, non-inverting and differential amplifiers with negative feedback.

    Examined in the 70-mark end-semester paper

    • Differential amplifiers, current sources and level shifting
    • Op-amp block diagram and ideal characteristics
    • Difference amplifier, virtual short and negative feedback
    • Inverting and non-inverting amplifiers
  2. Unit 2: Practical Op-Amp and Frequency Response

    6 hours

    Input offset voltage, bias and offset currents, total output offset voltage, thermal drift, PSRR, CMRR and slew rate; IC 741 characteristics; the high-frequency equivalent circuit and frequency compensation.

    Examined in the 70-mark end-semester paper

    • Op-amp parameters: DC and AC
    • Frequency response of op-amp circuits and Bode plots
    • Op-amp frequency compensation
  3. Unit 3: General Linear Applications of Op-Amp

    7 hours

    Summing, scaling and averaging amplifiers, the adder-subtractor; the instrumentation amplifier and its ICs; V-to-I and I-to-V converters; the op-amp differentiator and integrator and their frequency response.

    Examined in the 70-mark end-semester paper

    • Voltage follower, summing and differential amplifiers
    • Instrumentation amplifier
    • V-F, I-V and V-I converters
    • Practical integrator and differentiator
  4. Unit 4: Non-Linear Applications

    7 hours

    Comparator, zero-crossing detector, Schmitt trigger and window detector; sample-and-hold and peak detector; precision rectifiers; log and antilog amplifiers; op-amp clippers and clampers.

    Examined in the 70-mark end-semester paper

    • Comparators and the Schmitt trigger
    • Zero-crossing and window detectors
    • Sample-and-hold circuits
    • Peak detectors and analog multipliers
    • Precision half-wave and full-wave rectifiers
    • Logarithmic and antilog amplifiers
    • Clippers and clampers using op-amps
  5. Unit 5: Active Filters and Waveform Generators

    7 hours

    Advantages of active filters; first- and second-order Butterworth low-pass and high-pass filters; square, triangular and sawtooth generators; phase-shift, Wien bridge and quadrature oscillators.

    Examined in the 70-mark end-semester paper

    • First and second-order active filters
    • Square and triangular wave generators
    • Barkhausen criterion and types of oscillators
    • RC phase-shift oscillator
    • Wien bridge oscillator
  6. Unit 6: Special ICs and their Applications

    7 hours

    The phase-locked loop and the 565 PLL with applications; LM317 and LM337 regulators; the IC 555 timer in astable and monostable modes and its applications.

    Examined in the 70-mark end-semester paper

    • Phase-locked loop and its applications
    • Adjustable regulators: IC 317 and IC 337
    • IC 555 timer
    • Astable and monostable multivibrators

Unit contents are summarised from the official PAHSU syllabus . AiCanCode.org is not affiliated with Punyashlok Ahilyadevi Holkar Solapur University (PAHSU).