PAHSU SY Electrical syllabus

PAHSU · Second Year B.Tech. Electrical Engineering · NEP 2020

Analog Electronics

EEPCC-01 · Semester III · 3 credits · ISE 30 + ESE 70

  1. Unit 1: Semiconductor Devices and Their Applications

    8 hours

    Zener diodes and LEDs: construction, operation, V-I characteristics and applications; diodes as clippers and clampers; DC analysis of the BJT: load line, thermal runaway, stability factor and fixed, collector-to-base and self-bias circuits.

    Examined in the 70-mark end-semester paper

    • PN junction and Zener diodes
    • LEDs and opto-isolators
    • Clippers, clampers and RC wave-shaping circuits
    • Load line and transistor biasing
    • BJT biasing, Q-point and bias stability
  2. Unit 2: Frequency Response of BJT Amplifier

    6 hours

    Frequency response of the CE amplifier; effect of the emitter, coupling and input capacitors on the response of an RC-coupled CE amplifier; designing a single-stage RC-coupled BJT amplifier.

    Examined in the 70-mark end-semester paper

    • Frequency response of a CE amplifier
    • Frequency response and 3 dB bandwidth
    • Small-signal analysis of single-stage amplifiers
    • Cascaded amplifiers and classification of amplifiers
  3. Unit 3: Field Effect Transistor

    6 hours

    JFET types, construction, operation, characteristics and small-signal parameters; construction, operation and characteristics of depletion and enhancement MOSFETs.

    Examined in the 70-mark end-semester paper

    • JFET characteristics
    • MOSFET characteristics
    • FET biasing and FET amplifiers
  4. Unit 4: Operational Amplifier

    7 hours

    Differential amplifiers and their types; block diagram of a typical op-amp; ideal and practical (IC 741) characteristics: offset voltage and current, bias current, CMRR, SVRR, gain, output swing, slew rate and gain-bandwidth product; the op-amp equivalent circuit and ideal voltage transfer curve.

    Examined in the 70-mark end-semester paper

    • Differential amplifiers, current sources and level shifting
    • Ideal op-amp and its parameters
    • Op-amp AC and DC parameters and their measurement
    • Frequency response of op-amps
  5. Unit 5: Configurations of Operational Amplifier

    7 hours

    Open-loop differential, inverting and non-inverting configurations; voltage-series, voltage-shunt, current-series and current-shunt feedback; gain, input and output resistance, bandwidth and output offset with feedback; the virtual ground.

    Examined in the 70-mark end-semester paper

    • Open-loop and closed-loop op-amp configurations
    • Inverting and non-inverting amplifiers
    • Op-amp characteristics
  6. Unit 6: Applications of Operational Amplifier

    7 hours

    Voltage follower, current-to-voltage and voltage-to-current converters with floating and grounded loads; adders and subtractors; instrumentation amplifier; integrator and differentiator.

    Examined in the 70-mark end-semester paper

    • V-I and I-V converters
    • Op-amp summing and difference amplifiers
    • Instrumentation amplifier
    • Op-amp integrator, differentiator and precision rectifier

Unit contents are summarised from the official PAHSU syllabus . AiCanCode.org is not affiliated with Punyashlok Ahilyadevi Holkar Solapur University (PAHSU).