PAHSU Final Year E&TC syllabus

PAHSU · Final Year B.Tech. Electronics and Telecommunication Engineering · NEP 2020

CMOS VLSI

ENTPEC-04A · Programme Elective IV · Semester VII · 4 credits · End-semester 100 only

One of the Programme Elective IV options.

  1. Unit 1: CMOS Fabrication and Process Technology

    8 hours

    The IC fabrication process: wafer preparation and crystal growth, oxidation, lithography, diffusion and ion implantation, epitaxy, metallisation and CMP; n-well, p-well and twin-well CMOS process flows.

    Examined in the 100-mark end-semester paper

    • Silicon refining and crystal growth
    • Thermal oxidation
    • Epitaxy: VPE and MBE
    • Metallization and CMP
    • CMOS fabrication: photolithography, diffusion, ion implantation and the twin-tub process
  2. Unit 2: Circuit Design Processes

    6 hours

    MOS layers, stick diagrams, lambda-based design rules and layouts.

    Examined in the 100-mark end-semester paper

    • Stick diagrams and cell layout
    • Lambda design rules and DRC
  3. Unit 3: CMOS Inverter and Delay Analysis

    10 hours

    CMOS inverter structure and operation, DC and voltage-transfer characteristics, noise margins and switching threshold; rise and fall times and propagation-delay models; static, dynamic and short-circuit power; the energy-delay product and the power-delay trade-off.

    Examined in the 100-mark end-semester paper

    • CMOS inverter characteristics
    • Noise margins and the beta ratio
    • CMOS delay and power dissipation
    • Power dissipation and power-delay product
  4. Unit 4: Sequential Logic Design in CMOS

    8 hours

    Static latches and registers: bistability, multiplexer-based latches, master-slave edge-triggered registers, low-voltage static latches, static SR flip-flops; dynamic latches and registers: the transmission-gate edge-triggered register, C²MOS and the true single-phase clocked register.

    Examined in the 100-mark end-semester paper

    • Static and dynamic latches, flip-flops and registers
    • C2MOS and true single-phase clocked registers
  5. Unit 5: Timing Issues in Digital Circuits

    8 hours

    Synchronous, mesochronous, plesiochronous and asynchronous interconnect; clock skew, jitter and distribution; latch-based clocking; synchronisers and arbiters; PLLs for clock synchronisation.

    Examined in the 100-mark end-semester paper

    • Clock skew, jitter and distribution
    • Metastability and synchronisers
    • Clock management in FPGAs
  6. Unit 6: Arithmetic and Memory Building Blocks

    8 hours

    Fast adders and multipliers and other arithmetic building blocks; ROM, DRAM and SRAM design.

    Examined in the 100-mark end-semester paper

    • Adders and multipliers: ripple-carry and carry-look-ahead
    • Booth and Baugh–Wooley multipliers
    • Datapath components: comparators, shifters, decoders and encoders
    • Semiconductor memory cells: ROM, SRAM and DRAM

Unit contents are summarised from the official PAHSU syllabus . AiCanCode.org is not affiliated with Punyashlok Ahilyadevi Holkar Solapur University (PAHSU).