PAHSU Final Year Electrical syllabus

PAHSU · Final Year B.Tech. Electrical Engineering · NEP 2020

Power Quality & FACTS

EEPCC-13 · Semester VII · 3 credits · ISE 30 + ESE 70

  1. Unit 1: Introduction to Power Quality

    6 hours

    Terms and definitions: overloading, under- and over-voltage; voltage transients, short- and long-duration variations, interruptions, sags, swells, imbalance, fluctuation and power-frequency variation; power quality in PV and wind systems; international power quality standards.

    Examined in the 70-mark end-semester paper

    • Power quality terms as per IEEE 1159
    • Causes and effects of power quality disturbances
    • Voltage sags and interruptions
    • Voltage flicker
    • Power quality in renewable systems
    • Power quality analysers and EN 50160
  2. Unit 2: Harmonics and Harmonic Evaluation

    6 hours

    Harmonic sources in commercial and industrial loads and in PV and wind converters; locating harmonic sources; system response; harmonics versus transients; effects of harmonics; voltage and current distortion and harmonic indices; interharmonics and resonance; IEEE and IEC harmonic standards.

    Examined in the 70-mark end-semester paper

    • Sources of harmonics
    • Effects of harmonics on machines, transformers and cables
    • Harmonic indices and THD
    • Interharmonics
    • Harmonic resonance
    • IEEE 519 harmonic limits
  3. Unit 3: Harmonic Filter Design and Power Quality Monitoring

    8 hours

    Need for mitigation; single- and double-tuned and high-pass passive filters and their design; shunt, series and hybrid active filters and their control; harmonic mitigation in renewable systems; monitoring, diagnosis and measurement equipment.

    Examined in the 70-mark end-semester paper

    • Passive and active harmonic filters
    • Shunt, series and hybrid active filters
    • Instantaneous PQ theory
    • Power quality monitoring
  4. Unit 4: FACTS Concepts and Static Shunt Compensator

    7 hours

    FACTS devices and their importance in transmission; basic types of controller; objectives of shunt compensation and methods of controllable VAR generation; SVC and STATCOM and their V-I and V-Q characteristics compared.

    Examined in the 70-mark end-semester paper

    • FACTS concepts and power flow control
    • Types of FACTS controllers
    • Static VAR generators: TCR, TSC and FC-TCR
    • STATCOM principle
    • SVC versus STATCOM
  5. Unit 5: Static Series Compensators

    7 hours

    Objectives of series compensation; variable-impedance GCSC, TSSC and TCSC and the switching-converter SSSC; their operating characteristics and applications; effect on power transfer capability and stability.

    Examined in the 70-mark end-semester paper

    • Objectives of series compensation
    • Series compensators: GCSC, TSSC, TCSC and SSSC
    • FACTS control for system stability
  6. Unit 6: Advanced FACTS Controllers

    6 hours

    Objectives of voltage and phase angle regulators, TCVR and TCPAR; operating principle and control structure of the UPFC; operating principle, characteristics, control and applications of the IPFC; UPFC versus IPFC.

    Examined in the 70-mark end-semester paper

    • Voltage and phase angle regulators: TCVR and TCPAR
    • Unified power flow controller
    • Interline power flow controller

Unit contents are summarised from the official PAHSU syllabus . AiCanCode.org is not affiliated with Punyashlok Ahilyadevi Holkar Solapur University (PAHSU).