Mumbai University · Second Year Mechanical Engineering · NEP 2020
Finite Element Analysis
2404111 · Semester IV · 3 credits · Internal tests 40 + end-semester 60
End-semester paper (2 hours): Six questions of 20 marks; Q1 is compulsory and you answer three.
Also carries 25 marks of term work, built on six software home exercises.
Module 1: Introduction
7 hoursHistory and terminology of FEM; nodes, elements, degrees of freedom, loads and constraints; steps of FEM; stress, equilibrium and boundary conditions; strain–displacement and stress–strain relations; von Mises stress; temperature effects; potential energy; Galerkin's method; the stiffness method.
Examined in one of the two internal tests and in the 60-mark end-semester paper
- Finite element terminology and steps
- Stress, strain and equilibrium relations
- Von Mises stress
- Potential energy and equilibrium
- Galerkin's method
- The stiffness (displacement) method
Module 2: Matrix Algebra and Gaussian Elimination
6 hoursMatrix multiplication and transposition; diagonal, symmetric and triangular matrices; determinants and inversion; eigenvalues and eigenvectors; Gaussian elimination.
Examined in one of the two internal tests and in the 60-mark end-semester paper
- Matrix operations for FEA
- Eigenvalues and eigenvectors in FEA
- Gaussian elimination
Module 3: 1D Elements
7 hoursDisplacement functions; global and local coordinates; element order; shape functions; stiffness matrices and load vectors for springs, bars, beams, trusses and plane frames; transformation matrices; assembly; half bandwidth; elimination and penalty approaches; symmetric boundary conditions; stresses.
Examined in one of the two internal tests and in the 60-mark end-semester paper
- Shape functions and their properties
- Bar and spring element stiffness matrices
- Beam element stiffness matrix
- Truss and plane frame elements
- Assembly of the global stiffness matrix
- Boundary conditions: elimination and penalty approaches
Module 4: 1D Steady-state Heat Transfer
6 hoursThe governing equation; 1D elements for conduction and convection; boundary conditions; temperature distribution.
Examined in one of the two internal tests and in the 60-mark end-semester paper
- 1D steady-state conduction elements
- Convection in 1D heat transfer elements
Module 5: Dynamic Analysis
6 hoursTypes of dynamic analysis; the equation of motion; lumped and consistent mass; mass matrices for bars and beams; undamped free vibration as an eigenvalue problem; natural frequencies and mode shapes.
Examined in one of the two internal tests and in the 60-mark end-semester paper
- Lumped and consistent mass matrices
- Free vibration and the eigenvalue problem
Module 6: 2D Elements
7 hoursSecond-order 2D equations; variational formulation; triangular elements, shape functions and element matrices; field problems and torsion of non-circular shafts; quadrilateral elements; stress analysis with the CST.
Examined in one of the two internal tests and in the 60-mark end-semester paper
- Variational formulation of 2D problems
- Constant strain triangle
- Quadrilateral elements
- Torsion of non-circular shafts by FEA
Module contents are summarised from the official Mumbai University syllabus . AiCanCode.org is not affiliated with the University of Mumbai.