Mumbai University SE EXTC syllabus

Mumbai University · Second Year Electronics and Telecommunication Engineering · NEP 2020

Electronic Devices and Linear Circuits

2303112 · Semester III · 3 credits · Internal tests 40 + end-semester 60

End-semester paper (2 hours): Six questions of 15 marks; Q1 is compulsory and you answer four. Each module's share of the paper follows its lecture hours.

  1. Module 1: Biasing of BJT and MOSFET

    6 hours

    BJT (CE) and E-MOSFET (CS) construction and characteristics; DC load line, Q-point and regions; fixed and voltage-divider bias; drain-to-gate and voltage-divider bias for E-MOSFETs.

    Examined in one of the two internal tests and in the 60-mark end-semester paper

    • BJT characteristics in CE configuration
    • Enhancement MOSFET: structure and characteristics
    • DC load line, Q-point and BJT biasing
    • MOSFET biasing and the DC load line
  2. Module 2: Small-signal Analysis of Amplifiers

    6 hours

    AC load line; CE amplifier with the hybrid-pi model; CS amplifier analysis; frequency response; coupling, bypass and parasitic capacitors; Miller's theorem.

    Examined in one of the two internal tests and in the 60-mark end-semester paper

    • Hybrid-pi model and CE amplifier analysis
    • Common-source amplifier and its AC analysis
    • Frequency response of the CS amplifier
    • Miller's theorem
  3. Module 3: Differential and Operational Amplifiers

    6 hours

    E-MOSFET differential amplifier, gains, CMRR and impedances; op-amp block diagram and characteristics; open and closed loop; inverting, non-inverting, summing and difference amplifiers.

    Examined in one of the two internal tests and in the 60-mark end-semester paper

    • MOSFET differential amplifier and CMRR
    • Op-amp block diagram and ideal characteristics
    • Inverting and non-inverting amplifiers
    • Voltage follower, summing and differential amplifiers
  4. Module 4: Op-amp Applications

    8 hours

    Integrators and differentiators; first and second-order active filters; comparators and Schmitt triggers; Barkhausen's criteria; RC phase-shift and Wien bridge oscillators.

    Examined in one of the two internal tests and in the 60-mark end-semester paper

    • Practical integrator and differentiator
    • First and second-order active filters
    • Comparators and the Schmitt trigger
    • Barkhausen criterion and types of oscillators
    • RC phase-shift oscillator
    • Wien bridge oscillator
  5. Module 5: IC 555 Timer

    6 hours

    Block schematic and working of the 555; monostable and astable design; pulse width and pulse position modulators.

    Examined in one of the two internal tests and in the 60-mark end-semester paper

    • IC 555 timer
    • Astable and monostable multivibrators using IC 555
    • PWM and PPM using IC 555
  6. Module 6: Voltage Regulators

    6 hours

    Regulated power supplies; 78XX and 79XX regulators; IC 723 for HVLC and HVHC; LM317 design.

    Examined in one of the two internal tests and in the 60-mark end-semester paper

    • Power supply block diagram and three-terminal regulators
    • IC 723 voltage regulator
    • Adjustable regulators: IC 317 and IC 337

Module contents are summarised from the official Mumbai University syllabus . AiCanCode.org is not affiliated with the University of Mumbai.