Mumbai University SE Electrical syllabus

Mumbai University · Second Year Electrical Engineering · NEP 2020

Power Electronics Devices and Circuits

2224113 · Semester IV · 3 credits · Internal tests 40 + end-semester 60

End-semester paper (2 hours): Six questions of 15 marks; Q1 is compulsory and you answer four.

  1. Module 1: Thyristors

    6 hours

    SCR modes and static characteristics; gate control; two-transistor analogy; ratings; R, RC and UJT ramp firing circuits; SCR protection.

    Examined in one of the two internal tests and in the 60-mark end-semester paper

    • SCR characteristics and ratings
    • Two-transistor analogy of the SCR
    • SCR triggering circuits
    • SCR protection
  2. Module 2: Power Semiconductor Devices

    8 hours

    Power diodes, BJTs, MOSFETs and IGBTs and their safe operating areas; comparison; SiC and GaN; conduction and switching losses; reading MOSFET and IGBT datasheets.

    Examined in one of the two internal tests and in the 60-mark end-semester paper

    • Power MOSFET and IGBT
    • Power diodes and power BJTs
    • Safe operating area
    • Wide-bandgap devices: SiC and GaN
    • Conduction and switching losses
  3. Module 3: Controlled Rectifiers

    8 hours

    Single-phase full-wave mid-point and bridge rectifiers with R and RL loads; rectification and inversion; dual converter; three-phase full converter with R load; single-phase PWM rectifier.

    Examined in one of the two internal tests and in the 60-mark end-semester paper

    • Single-phase fully controlled converter
    • Inversion mode of a fully controlled converter
    • Dual converter
    • Three-phase fully controlled converter
    • Single-phase PWM rectifier
  4. Module 4: DC-DC Switched-mode Converters

    6 hours

    PWM step-down operation; buck, boost and buck–boost converters in CCM with resistive load; output ripple; bidirectional converters; PFC circuits and LED drivers.

    Examined in one of the two internal tests and in the 60-mark end-semester paper

    • Buck converter
    • Boost converter
    • Buck-boost converter
    • Bidirectional DC-DC converters
    • Power factor correction and LED drivers
  5. Module 5: Inverters

    6 hours

    Single-phase half- and full-bridge inverters; voltage control; multiple and sinusoidal PWM; three-phase VSI in 120° and 180° modes; single-phase CSI; VSI versus CSI.

    Examined in one of the two internal tests and in the 60-mark end-semester paper

    • Single-phase full-bridge inverter
    • PWM techniques
    • Three-phase inverter: 120 and 180 degree modes
    • Current source inverters
  6. Module 6: Auxiliary Circuits

    5 hours

    Turn-off snubbers; gate drivers for MOSFETs and IGBTs: level shifters, bootstrap and isolated drivers; heat sinks and their calculation.

    Examined in one of the two internal tests and in the 60-mark end-semester paper

    • Snubber circuits
    • Gate drivers for MOSFET and IGBT
    • Heat sink design

Module contents are summarised from the official Mumbai University syllabus . AiCanCode.org is not affiliated with the University of Mumbai.