Mumbai University · Final Year Mechanical Engineering · Rev-2019 'C' Scheme
Vibration Controls
MEDLO7042 · Department Optional Course 4 · Semester VII · 3 credits · Internal tests 20 (average of two) + end-semester 80
End-semester paper (3 hours): Six questions of 20 marks; Q1 is compulsory and you answer four. Each module's share of the paper follows its lecture hours.
One of the Department Optional Course 4 options.
Module 1: Introduction
5 hoursReducing vibration at source; factors affecting vibration levels; isolating the source; methods of control; dynamic properties and selection of materials.
Examined in the 80-mark end-semester paper (about 13% of it, by lecture hours); the class tests cover what has been taught by then
- Vibration reduction at source
- Materials for vibration control
Module 2: Dynamic Vibration Absorbers
8 hoursNeutralisers and self-tuned pendulums; optimum damped absorbers; absorbers with springs and dashpots; gyroscopic and impact absorbers; absorbers on continuous systems.
Examined in the 80-mark end-semester paper (about 21% of it, by lecture hours); the class tests cover what has been taught by then
- Dynamic vibration absorbers
- Damped vibration absorbers
- Gyroscopic and impact absorbers
Module 3: Isolating Single-DOF Systems
8 hoursIsolators with complex stiffness and Coulomb damping; three-element and two-stage isolators; pneumatic suspension; negative stiffness.
Examined in the 80-mark end-semester paper (about 21% of it, by lecture hours); the class tests cover what has been taught by then
- Isolators with complex stiffness and Coulomb damping
- Two-stage and three-element isolators
- Pneumatic suspension and negative stiffness
Module 4: Active and Semi-active Control
8 hoursModelling active control; actuators and sensors; active absorption and damping; classical and optimal control; piezoelectric transducers; magneto-rheological fluids and devices; semi-active suspension.
Examined in the 80-mark end-semester paper (about 21% of it, by lecture hours); the class tests cover what has been taught by then
- Active vibration control
- Piezoelectric actuators
- Semi-active control and magneto-rheological fluids
Module 5: Active and Adaptive Absorbers
5 hoursActive tuned absorbers; active mass dampers; adaptive and semi-active tuned absorbers.
Examined in the 80-mark end-semester paper (about 13% of it, by lecture hours); the class tests cover what has been taught by then
- Active and adaptive tuned vibration absorbers
- Active mass dampers
Module 6: Active and Semi-active Isolation
5 hoursActive base and force isolation; piezoelectric stack isolators; semi-active and adaptive-passive isolation; active vehicle suspension.
Examined in the 80-mark end-semester paper (about 13% of it, by lecture hours); the class tests cover what has been taught by then
- Active and semi-active vibration isolation
- Adaptive-passive vibration isolation
- Active vehicle suspension
Module contents are summarised from the official Mumbai University syllabus . AiCanCode.org is not affiliated with the University of Mumbai.