Mumbai University BE Mechanical syllabus

Mumbai University · Final Year Mechanical Engineering · Rev-2019 'C' Scheme

Design of Mechanical System

MEC701 · Semester VII · 4 credits · Internal tests 20 (average of two) + end-semester 80

The syllabus prints no paper format for this course.

  1. Module 1: Design Methodology

    4 hours

    Methodology and morphology of design; optimum design; system concepts in design.

    Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then

    • Design methodology and morphology
    • Optimum design
    • System concepts in design
  2. Module 2: Design of Transmission Gearboxes

    12 hours

    Single- and two-stage fixed-ratio gearboxes with spur, helical, bevel and worm gear pairs; gearbox housing layout and design.

    Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then

    • Single and two-stage gearbox design
    • Design of spur and helical gear pairs
    • Design of bevel and worm gear pairs
    • Gearbox housing layout and design
  3. Module 3: Design of Hoisting Mechanisms

    10 hours

    Snatch block assembly: rope selection, sheave, hook and its bearing, cross piece, sheave axle and shackle plate; rope drum design; motor and transmission selection.

    Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then

    • Snatch block assembly design
    • Wire rope selection
    • Design of sheave, hook and cross piece
    • Design of rope drum and motor selection
  4. Module 4: Design of Belt Conveyors

    4 hours

    Power requirement; belt selection; take-up unit and idler pulleys.

    Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then

    • Belt conveyor power requirement
    • Belt selection, take-up unit and idlers
  5. Module 5: Engine Design

    10 hours

    Design of the cylinder, piston with pin and rings, connecting rod, and crankshaft with bearings for petrol and diesel engines.

    Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then

    • Design of cylinder and cylinder head
    • Design of piston, pin and rings
    • Design of connecting rod
    • Design of crankshaft and bearings
  6. Module 6: Design of Pumps

    8 hours

    Gear pump: motor selection, gears, shaft and bearings, casing and bolts, suction and delivery pipes; centrifugal pump: motor, pipes, impeller and shaft, volute casing.

    Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then

    • Design of gear pump components
    • Design of centrifugal pump impeller and shaft
    • Design of volute casing

Module contents are summarised from the official Mumbai University syllabus . AiCanCode.org is not affiliated with the University of Mumbai.