Mumbai University BE Mechanical syllabus

Mumbai University · Final Year Mechanical Engineering · Rev-2019 'C' Scheme

Composite Materials

MEDLO8051 · Department Optional Course 5 · Semester VIII · 3 credits · Internal tests 20 (average of two) + end-semester 80

One of the Department Optional Course 5 options. The syllabus prints no paper format for this course.

All notes for this subject
  1. Module 1: Introduction

    8 hours

    Classification by fibre and matrix; advantages and applications; hand and spray lay-up, vacuum bagging, prepregs and autoclaves; filament winding, pultrusion, RTM and vacuum infusion; powder metallurgy for ceramic and metal matrices.

    Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then

    • Classification of composites
    • Hand and spray lay-up and vacuum bagging
    • Filament winding, pultrusion and RTM
    • Metal and ceramic matrix composites
  2. Module 2: Analysis of a Lamina

    6 hours

    Hooke's law for different materials; plane stress; unidirectional and angle laminae; compliance, stiffness and engineering constants.

    Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then

    • Hooke's law for a unidirectional lamina
    • Compliance and stiffness matrices
    • Angle lamina and its constants
  3. Module 3: Lamina Failure Theories

    4 hours

    Maximum stress and strain theories; Tsai–Hill and Tsai–Wu; strength ratio; failure envelopes.

    Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then

    • Maximum stress and strain failure theories
    • Tsai–Hill and Tsai–Wu theories
    • Strength ratio and failure envelopes
  4. Module 4: Micromechanics and Laminate Design

    6 hours

    Lamina properties from fibre and matrix; laminate types and codes; laminate design.

    Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then

    • Micromechanics of a lamina
    • Laminate codes and design
  5. Module 5: Inspection of Composites

    6 hours

    Damage types; ultrasonic, acoustographic, low-frequency, radiographic, shearographic, acoustic emission and thermographic inspection.

    Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then

    • Damage in composites
    • NDT of composites
  6. Module 6: Repair of Composites

    6 hours

    Choosing a repair; repair criteria and designs; matrix cracks, delamination, holes and fibre fracture; damage removal and surface preparation.

    Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then

    • Repair of composites
    • Delamination and fibre fracture

Module contents are summarised from the official Mumbai University syllabus . AiCanCode.org is not affiliated with the University of Mumbai.