Mumbai University BE Electrical syllabus

Mumbai University · Final Year Electrical Engineering · Rev-2019 'C' Scheme

High Power Switching Converters

EEDO8014 · Department Optional Course 5 · Semester VIII · 3 credits · Internal tests 20 (average of two) + end-semester 80

End-semester paper (3 hours): Six questions of 20 marks; Q1 is compulsory and you answer four.

One of the Department Optional Course 5 options.

  1. Module 1: High Power Devices

    4 hours

    Diodes, SCRs, GTOs and IGBTs; market trends; series connection and voltage sharing; paralleling IGBTs; intelligent power modules; packaging; wide-bandgap devices.

    Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then

    • High power devices: GTOs and IGBTs
    • Series and parallel connection of devices
    • Intelligent power modules and packaging
  2. Module 2: High Power Converters and Protection

    10 hours

    Twelve- and higher-pulse rectifiers; cascaded H-bridge and modular multilevel converters; practical three-phase converters; over-current, over-voltage and thermal protection; snubber design.

    Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then

    • Twelve-pulse and higher-pulse rectifiers
    • Cascaded H-bridge multilevel inverters
    • Modular multilevel converters
    • Converter protection
    • Snubber design
  3. Module 3: Design Considerations

    6 hours

    Electrical, mechanical, environmental, EMI/EMC and hardware specifications; thermal management; choosing switching frequency, devices and topology; control, isolation and cost.

    Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then

    • Converter design specifications
    • Thermal management
    • Choosing switching frequency and topology
  4. Module 4: Closed-loop Control

    8 hours

    Analog and digital PWM; signal conditioning and sampling; single- and double-update modulators; discretising PI and PR controllers; computational delay; grid synchronisation; non-linear control.

    Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then

    • Analog and digital PWM control
    • Digital PWM: single and double update
    • PI and PR controller discretisation
    • Grid synchronisation techniques
  5. Module 5: High Power AC Drives

    5 hours

    Line- and motor-side requirements; device constraints; converter configurations; control; case studies.

    Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then

    • High power AC drive configurations
  6. Module 6: Grid-interfaced Converters

    6 hours

    Requirements; current and voltage control; synchronisation; filter design; DC-link control; renewable case studies.

    Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then

    • Grid-interfaced converter control
    • Grid filter design
    • DC link voltage control

Module contents are summarised from the official Mumbai University syllabus . AiCanCode.org is not affiliated with the University of Mumbai.