Mumbai University · Final Year Electrical Engineering · Rev-2019 'C' Scheme
Electrical Drives and Control
EEC701 · Semester VII · 3 credits · Internal tests 20 (average of two) + end-semester 80
End-semester paper (3 hours): Six questions of 20 marks; Q1 is compulsory and you answer four.
Module 1: Drive Dynamics
10 hoursParts and choice of drives; torque equations and multi-quadrant operation; equivalent drive parameters and measuring inertia; load torques; time and energy loss in transients; steady-state stability; load equalisation.
Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then
- Electric drive components
- Four-quadrant operation
- Equivalent drive parameters and moment of inertia
- Load torque and steady-state stability
- Time and energy loss in transients
- Load equalisation
Module 2: Selection of Motor Power Rating
5 hoursThermal model for heating and cooling; classes of duty; ratings for continuous, fluctuating, short-time and intermittent duty by equivalent current, torque and power.
Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then
- Motor duty classes and enclosures
- Thermal model of a motor
- Motor rating for fluctuating and intermittent loads
Module 3: Control of Electrical Drives
5 hoursModes of operation; speed transitions; static and dynamic performance; hysteresis current and PWM voltage control; closed-loop torque and speed control with an inner current loop.
Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then
- Hysteresis current control and PWM voltage control
- Closed-loop torque and speed control
Module 4: DC Drives
4 hoursMulti-quadrant DC motor characteristics; three-phase fully controlled converter and chopper drives for separately excited motors.
Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then
- Converter-fed DC drives
- Chopper-fed DC drives
Module 5: AC Drives
8 hoursInduction motor braking and plugging; stator voltage and V/f control; soft starting; V/f and self-controlled synchronous motor drives.
Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then
- Braking of induction motors
- Stator voltage and V/f control
- Synchronous motor variable-speed drives
Module 6: Advanced Control of Induction Motor Drives
7 hoursd-q model; field-oriented (vector) control and its DC-motor analogy; direct vector control; scalar versus vector control; direct torque and flux control with the switching table.
Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then
- Vector control of induction motors
- Direct torque control
Module contents are summarised from the official Mumbai University syllabus . AiCanCode.org is not affiliated with the University of Mumbai.