Mumbai University · Final Year Electrical Engineering · Rev-2019 'C' Scheme
Advanced Electric Drives
EEDO8013 · Department Optional Course 5 · Semester VIII · 3 credits · Internal tests 20 (average of two) + end-semester 80
End-semester paper (3 hours): Six questions of 20 marks; Q1 is compulsory and you answer four.
One of the Department Optional Course 5 options.
Module 1: Scalar Control of Induction Motors
8 hoursVariable-frequency operation; open- and closed-loop V/f control; current-controlled VSI and current-fed drives; flux-programmed efficiency optimisation.
Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then
- Open-loop and closed-loop V/f control
- Current-controlled VSI drives
- Current-fed inverter drives
- Efficiency optimisation by flux programming
Module 2: Vector Control
10 hoursDirect vector control; flux estimation by voltage and current models; indirect vector control; slip gain tuning; stator-flux-oriented control.
Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then
- Direct vector control
- Flux estimation: voltage and current models
- Indirect vector control
- Slip gain tuning
- Stator flux oriented control
Module 3: Sensorless Vector Control
5 hoursSlip calculation; direct synthesis; MRAS; speed-adaptive flux observers; extended Kalman filter.
Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then
- Sensorless vector control
- MRAS speed estimation
- Speed-adaptive flux observers
- Extended Kalman filter for drives
Module 4: Adaptive Control
5 hoursSelf-tuning control; MRAC; sliding mode, fuzzy and neural control.
Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then
- Self-tuning and model reference adaptive control
- Sliding mode control of drives
- Fuzzy and neural control of drives
Module 5: Direct Torque and Flux Control
5 hoursConventional DTC with the inverter voltage-vector switching table.
Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then
- Direct torque and flux control
- DTC switching table
Module 6: Synchronous Motor Drives
6 hoursSinusoidal SPM drives: V/Hz control, self-control and vector control.
Examined in the 80-mark end-semester paper; the class tests cover what has been taught by then
- V/Hz control of PM synchronous motors
- Self-control of synchronous motors
- Vector control of SPM machines
Module contents are summarised from the official Mumbai University syllabus . AiCanCode.org is not affiliated with the University of Mumbai.