KBCNMU TY E&TC syllabus

KBCNMU · Third Year B.E. Electronics & Telecommunication Engineering · NEP 2020

Microprocessors and Microcontrollers

EC-503 · Semester V · 3 credits · ISE 40 + ESE 60

  1. Unit 1: Microprocessor Fundamentals

    9 hours

    The microcomputer and its elements, address, data and control buses; the 8085 and 8086, their block and pin diagrams, the 8085's registers, ALU and buses, addressing modes and instruction format.

    Examined in the 60-mark end-semester paper

    • Components of a microcomputer
    • Microprocessor-based system and evolution
    • 8085 architecture and functional blocks
    • 8085 pin diagram and signals
    • 8085 addressing modes
    • 8086 architecture and memory segmentation
  2. Unit 2: Understanding Microcontrollers

    9 hours

    The evolution of microcontrollers and how the 8051, PIC, ATmega16 and ARM compare with microprocessors; Harvard and von Neumann architectures and choosing a microcontroller; the 8051's block diagram, registers, PSW, register banks, pins and ports.

    Examined in the 60-mark end-semester paper

    • Microprocessors versus microcontrollers
    • Von Neumann and Harvard, CISC and RISC architectures
    • Selecting a microcontroller
    • 8051 architecture and register set
    • 8051 pin diagram and port structure
    • 8051 memory organisation
  3. Unit 3: Microcontroller Programming

    9 hours

    8051/89C51 assembly programming from data sheets: assembler directives, simulators, emulators, debuggers and cross-C compilers; addressing modes, MOVC and MOVX, and the arithmetic, logic and compare instructions.

    Examined in the 60-mark end-semester paper

    • 8051 addressing modes and instruction set
    • 8051 assembly programming
    • Assemblers and assembler directives
    • 8051 programming in C: data types, time delays and I/O
  4. Unit 4: Timers, Serial Port and Interrupts

    9 hours

    The timer registers and TMOD, mode 1 and mode 2 timer and counter programming and TCON; serial communication, RS-232 and 8051 serial port programming with SCON, RI and TI, doubling the baud rate; interrupts versus polling and interrupt service routines.

    Examined in the 60-mark end-semester paper

    • 8051 timers, counters and delay generation
    • 8051 interrupts and serial communication
    • RS-232 interfacing with the 8051
    • 8051 interrupt priority and programming
  5. Unit 5: Industrial Interfacing

    9 hours

    Interfacing switches, LEDs, seven-segment displays, LCDs, ADCs, DACs, sensors, stepper and DC motors and relays; the 8255 programmable peripheral interface and the 8254 programmable timer.

    Examined in the 60-mark end-semester paper

    • Interfacing LEDs, relays and buzzers with the 8051
    • Interfacing LCD and seven-segment displays with the 8051
    • Interfacing ADCs and temperature sensors with the 8051
    • Interfacing stepper motors, keyboards and DACs with the 8051
    • 8255 programmable peripheral interface
    • 8254 programmable interval timer

Unit contents are summarised from the official KBCNMU syllabus . AiCanCode.org is not affiliated with Kavayitri Bahinabai Chaudhari North Maharashtra University (KBCNMU).