KBCNMU TY E&TC syllabus

KBCNMU · Third Year B.E. Electronics & Telecommunication Engineering · NEP 2020

Internet of Things

EC-508 · Semester V · 2 credits · ISE 40 + ESE 60

A multidisciplinary minor (MDM) course fixed in E&TC's own scheme: 2 credits, examined 40 + 60 in 3 hours, with a 25-mark internal continuous assessment besides.

  1. Unit 1: Introduction to IoT

    6 hours

    Definition and characteristics of IoT, its framework and architecture, physical design, protocols, communication models, levels and templates, and enabling technologies.

    Examined in the 60-mark end-semester paper

    • Physical and logical design of IoT
    • IoT reference architecture
    • IoT communication models and APIs
    • IoT PHY and MAC protocols
  2. Unit 2: Supporting Platforms of IoT

    6 hours

    Wireless sensor networks, cloud computing, embedded systems, big data analysis, UAVs and web services; IoT and M2M and how they differ.

    Examined in the 60-mark end-semester paper

    • RFID and wireless sensor networks
    • Edge computing versus cloud computing
    • M2M, devices and gateways
    • IoT data management and analytics
  3. Unit 3: Things in IoT

    6 hours

    Wireless, level and embedded sensors; actuators — connecting an LED and a buzzer, controlling AC power devices; the I2C, SPI, UART, USART and CAN protocols.

    Examined in the 60-mark end-semester paper

    • Sensors and actuators
    • Reading sensors
    • ESP32 and ESP8266 nodes with I2C, SPI and UART
  4. Unit 4: Communication Protocols and IoT Challenges

    6 hours

    Non-IP protocols — IEEE 802.11, IEEE 802.15, Bluetooth and ZigBee; IP-based protocols — IPv4, IPv6 and 6LoWPAN; the MQTT and AMQP application-layer protocols.

    Examined in the 60-mark end-semester paper

    • Bluetooth and Wi-Fi communication
    • 6LoWPAN and RPL
    • IPv6 and the transition from IPv4
    • MQTT and CoAP
    • DDS and AMQP
  5. Unit 5: IoT Platforms and Programming

    6 hours

    Installing the Arduino and Raspberry Pi, their serial, SPI and I2C interfaces, and Python programming on the Raspberry Pi.

    Examined in the 60-mark end-semester paper

    • Raspberry Pi and Arduino for IoT
    • Raspberry Pi GPIO and Linux setup
    • Python programming for IoT

Unit contents are summarised from the official KBCNMU syllabus . AiCanCode.org is not affiliated with Kavayitri Bahinabai Chaudhari North Maharashtra University (KBCNMU).