KBCNMU TY Civil syllabus

KBCNMU · Third Year B.E. Civil Engineering · NEP 2020

Structural Design and Drawing

CE-601 · Semester VI · 3 credits · ISE 40 + ESE 60

  1. Unit 1: Introduction and Design Philosophy

    9 hours

    Working stress and limit state methods, characteristic strengths and loads and partial safety factors, stress and strain diagrams, balanced, under- and over-reinforced sections, and singly reinforced beams.

    Examined in the 60-mark end-semester paper

    • Working stress and limit state methods
    • Characteristic loads, strengths and partial safety factors
    • Singly reinforced rectangular sections
  2. Unit 2: Design of Beams

    9 hours

    Doubly reinforced beams, simply supported and cantilever beams for flexure, shear and bond by the limit state method, and flanged L and T beams.

    Examined in the 60-mark end-semester paper

    • Doubly reinforced sections
    • Design for shear
    • Bond, development length and torsion
    • Flanged sections
  3. Unit 3: Design of Slabs

    9 hours

    One-way simply supported, cantilever and continuous slabs, and two-way simply supported and continuous slabs.

    Examined in the 60-mark end-semester paper

    • One-way slabs
    • Cantilever and continuous slabs
    • Two-way slabs
  4. Unit 4: Design of Columns

    9 hours

    Stress and strain in columns, axially loaded short columns with minimum eccentricity, and the concept and analysis of floating columns.

    Examined in the 60-mark end-semester paper

    • Short columns under axial load
    • Floating columns
  5. Unit 5: Footings and Staircase

    9 hours

    Isolated pad footings for axial load and uniaxial bending, and the dog-legged staircase.

    Examined in the 60-mark end-semester paper

    • Isolated footings
    • Eccentrically loaded footings
    • Dog-legged staircase

Unit contents are summarised from the official KBCNMU syllabus . AiCanCode.org is not affiliated with Kavayitri Bahinabai Chaudhari North Maharashtra University (KBCNMU).