KBCNMU SY E&TC syllabus

KBCNMU · Second Year B.E. Electronics & Telecommunication Engineering · NEP 2020

Solid State Devices and Circuits

EC-301 · Semester III · 3 credits · ISE 40 + ESE 60

Its subject is at the 55-topic cap, so h-parameter analysis, CS-CG-CD JFET stages and the cascade configurations are taught through the unit text and the linked topics.

  1. Unit 1: BJT Amplifiers

    9 hours

    Small-signal analysis of CE, CB and CC amplifiers with their biasing circuits using h-parameters: voltage and current gain, input and output resistance; converting CE and CC h-parameters, comparing the three configurations, and Miller's theorem and its dual.

    Examined in the 60-mark end-semester paper

    • BJT characteristics in CE configuration
    • DC load line, Q-point and BJT biasing
    • Hybrid-pi model and CE amplifier analysis
    • Miller's theorem
  2. Unit 2: FET Amplifiers

    9 hours

    Operating points of the JFET and depletion and enhancement MOSFETs (IDQ, VDSQ, VGSQ), and small-signal analysis of JFET common-source, common-gate and common-drain amplifiers with their biasing circuits.

    Examined in the 60-mark end-semester paper

    • JFET characteristics and parameters
    • JFET amplifiers and biasing
    • MOSFET biasing and the DC load line
    • Common-source amplifier and its AC analysis
    • Source follower
  3. Unit 3: Frequency Response and Cascade Amplifiers

    9 hours

    Frequency response of single-stage and cascaded BJT amplifiers; the CE-CE, CE-CB and CE-CC cascades and the Darlington configuration, with their biasing circuits.

    Examined in the 60-mark end-semester paper

    • RC-coupled CE amplifier and its frequency response
    • Frequency response of the CS amplifier
  4. Unit 4: Regulators

    9 hours

    The BJT series regulator with the stability factor Sv and output resistance Ro; the LM 317, LM 337 and LM 340 regulators and the dual-tracking regulator; buck and boost switching regulators.

    Examined in the 60-mark end-semester paper

    • Series and shunt transistor voltage regulators
    • Power supply block diagram and three-terminal regulators
    • Adjustable regulators: IC 317 and IC 337
    • SMPS: buck and boost converters
  5. Unit 5: Thyristor Devices

    9 hours

    Working and I-V characteristics of the SCR, TRIAC, power MOSFET, IGBT and UJT, and the UJT relaxation oscillator.

    Examined in the 60-mark end-semester paper

    • SCR construction and characteristics
    • GTO, TRIAC and UJT
    • Power MOSFET and IGBT

Unit contents are summarised from the official KBCNMU syllabus . AiCanCode.org is not affiliated with Kavayitri Bahinabai Chaudhari North Maharashtra University (KBCNMU).