KBCNMU SY Electrical syllabus

KBCNMU · Second Year B.E. Electrical Engineering · NEP 2020

Analog and Digital Electronics

EE-403 · Semester IV · 3 credits · ISE 40 + ESE 60

  1. Unit 1: BJT and Applications

    9 hours

    Transistor characteristics and the transistor as an amplifier; CB, CE and CC configurations; operating point, self-bias, bias compensation, thermal runaway and stability; the CE amplifier at low frequencies, gain-bandwidth product, emitter follower, RC-coupled and multistage amplifiers.

    Examined in the 60-mark end-semester paper

    • Load line and transistor biasing
    • Small-signal analysis of single-stage amplifiers
    • Emitter follower, Darlington and bootstrap circuits
    • Frequency response and 3 dB bandwidth
    • Cascaded amplifiers and classification of amplifiers
  2. Unit 2: Operational Amplifier

    9 hours

    Op-amp parameters: CMRR, slew rate, frequency response and gain limits; inverting and non-inverting amplifiers, summer and subtractor; integrator, differentiator, comparator, Schmitt trigger and instrumentation amplifier; sine, square and triangular waveform generation.

    Examined in the 60-mark end-semester paper

    • Ideal op-amp and its parameters
    • Inverting and non-inverting amplifiers
    • Op-amp integrator, differentiator and precision rectifier
    • Comparators and zero-crossing detectors
    • Schmitt trigger
    • Instrumentation amplifier
    • Op-amp waveform generators
  3. Unit 3: Timer and Voltage Regulators

    9 hours

    The IC 555 timer: block diagram, astable and monostable modes; series and shunt regulators and their protection; fixed and variable IC regulators 78xx, 79xx, LM723 and LM317; the VCO and PLL.

    Examined in the 60-mark end-semester paper

    • IC 555 timer
    • Astable and monostable multivibrators
    • Voltage regulators: 78xx, 79xx and LM317
    • Op-amp linear voltage regulators and IC 723
    • Phase-locked loop and its applications
  4. Unit 4: Combinational Circuits

    9 hours

    SOP and POS forms; Karnaugh maps for two to four variables, minimisation and don't-care conditions; half and full adders and subtractors, look-ahead carry; BCD-to-7-segment decoder, binary-Gray code converters; encoders, multiplexers and demultiplexers.

    Examined in the 60-mark end-semester paper

    • SOP and POS reduction
    • Karnaugh maps
    • Half and full adders
    • Code converters and comparators
    • Encoders and decoders
    • Multiplexers and demultiplexers
  5. Unit 5: Flip-Flops and Sequential Circuits

    9 hours

    The one-bit memory cell; clocked SR, edge-triggered JK, master-slave JK, D and T flip-flops and the race-around condition; synchronous and asynchronous sequential circuits; registers and shift registers; ring and twisted-ring counters; ripple and synchronous counters, the 4-bit up/down counter.

    Examined in the 60-mark end-semester paper

    • Latches and flip-flops
    • Shift registers
    • Ring and twisted-ring counters
    • Asynchronous counters
    • Synchronous counter design
    • Up-down and mod-N counters

Unit contents are summarised from the official KBCNMU syllabus . AiCanCode.org is not affiliated with Kavayitri Bahinabai Chaudhari North Maharashtra University (KBCNMU).