KBCNMU SY Computer syllabus

KBCNMU · Second Year B.E. Computer Engineering · NEP 2020

Analog Electronics and Signal System

CS-406 · Semester IV · 2 credits · ISE 40 + ESE 60

A fixed multidisciplinary-minor (MDM) course of the Computer branch: 2 credits, with 25 marks of internal continuous assessment besides ISE 40 + ESE 60. The syllabus prints no ESE duration for it.

  1. Unit 1: Operational Amplifier

    6 hours

    The IC 741 and its pins; open- and closed-loop amplifiers; offset voltages and currents, bias current, CMRR, slew rate and frequency response; inverting and non-inverting amplifiers, summing and differential amplifiers, integrator, differentiator, comparator, V-I and I-V converters.

    Examined in the 60-mark end-semester paper

    • Op-amp block diagram and ideal characteristics
    • Op-amp parameters: offset, bias current, CMRR and slew rate
    • Frequency response of op-amp circuits and Bode plots
    • Inverting and non-inverting amplifiers
    • Voltage follower, summing and differential amplifiers
    • Practical integrator and differentiator
    • Comparators and the Schmitt trigger
    • V-F, I-V and V-I converters
  2. Unit 2: Applications of Op-Amp

    6 hours

    Instrumentation, log and antilog amplifiers, the Schmitt trigger, and astable, monostable and bistable multivibrators.

    Examined in the 60-mark end-semester paper

    • Instrumentation amplifier
    • Logarithmic and antilog amplifiers
    • Op-amp monostable and bistable multivibrators
    • Square and triangular wave generators
  3. Unit 3: Filters and Converters

    6 hours

    Op-amp active low-pass, high-pass, band-pass and band-stop filters and their design; weighted-resistor and R-2R ladder DACs; single-slope, dual-slope and successive-approximation ADCs; switched-capacitor circuits.

    Examined in the 60-mark end-semester paper

    • First and second-order active filters
    • Notch and all-pass filters
    • Weighted-resistor and R-2R ladder DACs
    • Single-slope ADC
    • SAR, flash and dual-slope ADCs
    • Switched-capacitor circuits: building blocks and operation
  4. Unit 4: Introduction to Signals and Systems; Fourier Series

    6 hours

    Elementary continuous- and discrete-time signals, their classification and basic operations; static and dynamic, linear and non-linear, time-variant and time-invariant, stable and unstable systems; trigonometric and exponential Fourier series, Parseval's identity.

    Examined in the 60-mark end-semester paper

    • Elementary signals and their relationships
    • Classification of signals
    • Operations on signals
    • Classification of systems
    • Fourier series with period 2π and 2l
    • Trigonometric and exponential Fourier series
  5. Unit 5: Laplace Transforms

    6 hours

    Definition and region of convergence, transforms of important functions, the initial- and final-value theorems, the convolution integral, and the Laplace transform applied to series R-L and R-C circuits.

    Examined in the 60-mark end-semester paper

    • Laplace transform and region of convergence
    • Laplace transforms of standard functions
    • Properties of the Laplace transform
    • Convolution theorem
    • Circuit analysis and transfer functions with the Laplace transform

Unit contents are summarised from the official KBCNMU syllabus . AiCanCode.org is not affiliated with Kavayitri Bahinabai Chaudhari North Maharashtra University (KBCNMU).