GUG TY Electrical syllabus

GUG · Third Year B.Tech. Electrical Engineering · NEP 2020

Power System Operation and Control

STPECELE605B · Program Elective II · Semester VI · 3 credits · IE 10 + mid-semester 10 + ESE 80

One of the Program Elective II options.

  1. Unit 1: Load Frequency Control

    9 hours

    Speed governing, load sharing between parallel machines and control areas; static and dynamic analysis of single- and two-area systems; state-variable models and frequency-bias tie-line control.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Speed governing and turbine models
    • Load frequency control of an isolated system
    • Steady state and dynamic response of LFC
    • Two-area load frequency control
    • Governor dead band and automatic generation control
  2. Unit 2: Reactive Power and Voltage Control

    9 hours

    Excitation system models; generation and absorption of reactive power; on-load tap changers, generator voltage settings and switched capacitors; voltage profiles and loss minimisation.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Types of excitation systems
    • Production and absorption of reactive power
    • Methods of voltage control
    • Tap-changing transformers and ULTC control
    • Shunt reactors, series and shunt capacitors
  3. Unit 3: Economic Operation of Power Systems

    9 hours

    The economic dispatch problem, incremental cost curves and coordination equations with and without losses; direct and lambda-iteration methods; load and duration curves, diversity, capacity and utilisation factors.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Incremental cost curves
    • Economic dispatch by Lagrange multipliers
    • Penalty factor and B-coefficients
    • Load curves and load factors
  4. Unit 4: Unit Commitment

    9 hours

    Spinning reserve, thermal, hydro and fuel constraints; the priority-list method and forward dynamic programming.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Unit commitment constraints
    • Unit commitment by priority list and dynamic programming
  5. Unit 5: Computer Control of Power Systems

    9 hours

    The need for computer control; energy control and load dispatch centres; SCADA and EMS functions.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Energy control centres, SCADA and EMS
    • Power system security and contingency analysis

Unit contents are summarised from the official GUG syllabus . AiCanCode.org is not affiliated with Gondwana University, Gadchiroli.