1. Unit 1: Basic Concepts

    9 hours

    Evolution and structure of power systems, bulk grids and microgrids; conventional and renewable generation, distributed energy resources and storage; transmission and distribution line diagrams, voltage levels and topologies; synchronous grids and DC interconnections; three-phase circuits, power transfer and reactive power.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Structure of a power system
    • Microgrid architecture
    • Distributed generation and IEEE 1547
    • Need for energy storage
    • Choice of transmission voltage
    • Real and reactive power in three-phase circuits
  2. Unit 2: System Components

    9 hours

    Overhead lines and cables: fields around conductors, corona, line and cable parameters, inductance and capacitance; travelling-wave equations; short, medium and long lines, power transfer, voltage profile and reactive power; surge impedance loading; series and shunt compensation. Transformers: three-phase connections and phase shifts, three-winding and autotransformers, neutral-grounding transformers, tap changing and per-phase equivalents.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Corona and corona loss
    • Inductance of three-phase lines and transposition
    • Capacitance of three-phase lines
    • Underground cables and dielectric stress
    • Performance of short lines
    • Nominal-T and nominal-pi models
    • Long transmission lines
    • Surge impedance loading
    • Series and shunt compensation
    • Three-phase transformer connections
    • On-load tap changers
  3. Unit 3: Voltages and Insulation Requirements

    9 hours

    Lightning and switching overvoltages and protection against them; insulation coordination; propagation of surges and the voltages they produce; Bewley lattice diagrams.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Travelling waves and switching and lightning surges
    • Insulation coordination and overvoltage protection
    • Bewley's lattice diagram
  4. Unit 4: Fault Analysis and Protection Systems

    9 hours

    Symmetrical components; balanced and unbalanced faults; sequence networks of generators, lines and transformers; fault currents; neutral grounding. Switchgear: types of circuit breakers; protection attributes and back-up; overcurrent, directional, distance and differential protection.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Symmetrical components
    • Sequence impedances and sequence networks
    • Single line-to-ground fault
    • Line-to-line fault
    • Double line-to-ground fault
    • Neutral grounding: solid, resistance and reactance
    • Air-break, oil and air-blast circuit breakers
    • Primary and backup protection
    • Overcurrent and directional relays
    • Distance relays: impedance, reactance and mho
    • Percentage differential relays
  5. Unit 5: Introduction to DC Transmission and Renewable Energy Systems

    9 hours

    LCC and VSC DC links and real power control; AC versus DC transmission. Solar PV I-V and P-V characteristics and the power-electronic grid interface; wind turbine power curves, fixed- and variable-speed turbines, PMSG and induction generators and their grid interfaces.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Graetz bridge and HVDC power flow
    • VSC HVDC
    • HVDC versus EHVAC transmission
    • Grid-connected solar PV
    • Wind turbine characteristics
    • Grid-connected wind systems

Unit contents are summarised from the official GUG syllabus . AiCanCode.org is not affiliated with Gondwana University, Gadchiroli.