GUG TY Electrical syllabus

GUG · Third Year B.Tech. Electrical Engineering · NEP 2020

Power Electronics

STPCCELE603 · Semester VI · 3 credits · IE 10 + mid-semester 10 + ESE 80

  1. Unit 1: Power Electronic Switches, Connections, Protection and Switching Circuits

    9 hours

    The thyristor family, the two-transistor model of the SCR, gate characteristics, turn-on and turn-off; diodes, BJTs, MOSFETs and IGBTs as switches; SCR firing circuits; AC control with TRIAC and DIAC; series and parallel SCRs and equalising circuits; gate, overcurrent and overvoltage protection and snubber design.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • SCR characteristics and ratings
    • Two-transistor analogy of the SCR
    • SCR triggering circuits
    • Power MOSFET and IGBT
    • TRIAC
    • Series and parallel operation of SCRs
    • SCR protection
    • Snubber circuits
  2. Unit 2: Controlled Rectifiers

    9 hours

    Single-phase controlled rectifiers with R, R-L and R-L-E loads; source inductance; three-phase rectifiers; dual converters; power factor and harmonics.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Single-phase half-controlled converter
    • Single-phase fully controlled converter
    • Effect of source inductance and overlap angle
    • Three-phase fully controlled converter
    • Dual converter
    • Converter performance parameters
  3. Unit 3: DC-DC Converters

    9 hours

    Step-up and step-down converters with various loads; buck, boost, buck-boost and Cuk regulators; isolated converters; switched-mode, resonant and bidirectional power supplies.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Buck converter
    • Boost converter
    • Buck-boost converter
    • Flyback, forward and push-pull converters
    • Switched mode power supplies
    • Resonant converters: ZCS and ZVS
    • Bidirectional DC-DC converters
  4. Unit 4: Inverters

    9 hours

    Single- and three-phase bridge VSIs, 120° and 180° conduction, series and parallel inverters; voltage control and PWM, space-vector modulation; current source inverters; PWM rectifiers, the dual active bridge and multilevel inverters.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Single-phase full-bridge inverter
    • Three-phase inverter: 120 and 180 degree modes
    • Voltage control of single and three-phase inverters
    • PWM techniques
    • Series, parallel and class E resonant inverters
    • Current source inverters
    • Three-phase PWM rectifier
    • Multilevel inverters
  5. Unit 5: AC Voltage Controllers

    9 hours

    On-off and phase control, single- and three-phase AC voltage controllers; cycloconverters: single-phase, three-phase half-wave, three-phase output and load-commutated.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Single-phase AC voltage controller
    • Integral cycle control
    • Cycloconverters

Unit contents are summarised from the official GUG syllabus . AiCanCode.org is not affiliated with Gondwana University, Gadchiroli.