GUG TY Electrical syllabus

GUG · Third Year B.Tech. Electrical Engineering · NEP 2020

Advanced Microprocessor System and Microcontroller

STPECELE606A · Program Elective III · Semester VI · 3 credits · IE 10 + mid-semester 10 + ESE 80

One of the Program Elective III options.

  1. Unit 1: Advanced Microprocessor Architecture

    9 hours

    Microprocessor fundamentals; 8086 and Pentium architecture; pipelining and superscalar execution; cache organisation and the memory hierarchy; virtual memory; interrupts; DMA.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • 8086 architecture and memory organisation
    • Pentium architecture, pipelining and superscalar execution
    • Cache memory and mapping functions
    • Virtual memory: paging and segmentation
    • Interrupt service routines
  2. Unit 2: Memory and Peripheral Interfacing

    9 hours

    Memory interfacing and address decoding; the 8255 PPI, 8254 timer, 8259 interrupt controller, 8251 USART and serial communication; the 8237 DMA controller.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Memory interfacing and address decoding
    • 8255 programmable peripheral interface
    • 8253/8254 timer, 8259 interrupt controller and 8251 USART
    • DMA and the 8237 DMA controller
  3. Unit 3: Advanced Microcontrollers and ARM Architecture

    9 hours

    Embedded systems; 8051 architecture and the enhanced 8051 family; the ARM Cortex-M architecture, programming model, registers and instruction set; timers, counters, watchdog timers, interrupts and power management.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • 8051 architecture
    • 8051 timers and counters
    • 8051 interrupts
    • 8051 ports and power control
    • ARM core architecture and Thumb instruction set
    • On-chip peripherals of ARM controllers
  4. Unit 4: Embedded System Design and Communication Protocols

    9 hours

    Embedded C, development environments and debugging; GPIO, ADC, DAC and PWM; UART, SPI and I²C; sensor and actuator interfacing.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • 8051 development tools and programming in C
    • ADC interfacing
    • Serial communication: UART, SPI and I2C
    • Sensors for embedded systems
    • Actuators, displays, opto-isolators and relays
  5. Unit 5: Applications of Advanced Microcontrollers

    9 hours

    IoT-enabled embedded systems; smart energy management; industrial automation and process control; motor control.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • IoT with Arduino and Raspberry Pi
    • Microprocessor applications in measurement and control
    • Motor control with the 8051

Unit contents are summarised from the official GUG syllabus . AiCanCode.org is not affiliated with Gondwana University, Gadchiroli.