GUG TY Civil syllabus

GUG · Third Year B.Tech. Civil Engineering · NEP 2020

Pavement Design

STPECCEC606A · Elective III · Semester VI · 3 credits · IE 10 + mid-semester 10 + ESE 80

One of the Elective III options.

  1. Unit 1: General and Design Parameters

    7 hours

    Design factors and components of flexible and rigid pavements, highway and airfield pavements; design wheel load, standard axle and wheel assemblies, aircraft undercarriages, load repetitions and traffic distribution, the serviceability concept.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Types of pavements
    • Factors affecting pavement design
    • Wheel loads for highways and airports
    • ESWL and equivalent wheel load factors
  2. Unit 2: Material Characteristics

    9 hours

    AASHO classification, CBR, North Dakota cone bearing, plate load test for k-value and elastic properties of subgrades; Marshall mix design and bituminous surfacings and binder courses; modulus of rupture, elasticity, Poisson's ratio and thermal expansion of concrete; layer equivalence.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Subgrade soil and CBR test
    • Marshall mix design
    • Layered theory of flexible pavements
  3. Unit 3: Analysis and Design of Highway Pavements

    11 hours

    Stresses, strains and deflections by Boussinesq's one-layer and Burmister's two- and three-layer theories; load and temperature stresses in rigid pavements, influence charts, ultimate load analysis and joints; flexible design by North Dakota cone, IRC, Kansas triaxial and AASHTO; rigid design by IRC, PCA and AASHTO, joints and reinforcement.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Stresses in rigid pavements
    • Westergaard's analysis
    • Flexible pavement design to IRC 37
    • AASHTO and Asphalt Institute methods
    • Rigid pavement design to IRC 58
    • PCA method for rigid pavements
    • Joints in concrete pavements
  4. Unit 4: Airfield Pavement Design

    9 hours

    Flexible design by FAA, US Corps of Engineers, CBR and McLeod methods; rigid design by FAA, PCA and LCN; ACN, PCN and LCN and calculating LCN; ultimate load analysis and yield-line patterns.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Aircraft loads on pavements
    • Airport pavement design methods
  5. Unit 5: Evaluation and Strengthening of Pavements

    10 hours

    Field density, CBR and plate load tests; failures of flexible and rigid pavements, condition surveys, unevenness, rut depth, profilometers and bump integrators, Benkelman beam studies; flexible, composite and rigid overlays, repair, maintenance and rehabilitation.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Pavement evaluation and maintenance
    • Overlay design by the Benkelman beam method
    • Overlay design to IRC 81
    • Pavement management systems

Unit contents are summarised from the official GUG syllabus . AiCanCode.org is not affiliated with Gondwana University, Gadchiroli.