GUG TY Civil syllabus

GUG · Third Year B.Tech. Civil Engineering · NEP 2020

Design of RC Structures

STPCCCEC603 · Semester VI · 3 credits · IE 10 + mid-semester 10 + ESE 80

  1. Unit 1: Working Stress Method

    8 hours

    Basic concepts of flexural design, assumptions and design constants; balanced, under- and over-reinforced rectangular sections; drawbacks of the method; shear reinforcement; singly and doubly reinforced and T-beams by WSM.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Design of RC sections by the working stress method
    • Singly and doubly reinforced beams by WSM
  2. Unit 2: Limit State Design; Shear, Bond and Flexure

    8 hours

    Probabilistic and limit state design, characteristic values and partial safety factors, stress-block parameters and reinforcement; serviceability and collapse and IS 456:2000; design for shear, shear mechanisms and failure modes, development length; singly and doubly reinforced rectangular sections and failure modes.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Working stress and limit state methods
    • Characteristic loads, strengths and partial safety factors
    • Design for shear
    • Bond, development length and torsion
    • Singly reinforced rectangular sections
    • Doubly reinforced sections
  3. Unit 3: Flanged Beams, Columns and Serviceability

    12 hours

    T- and L-beams in flexure; columns under uniaxial bending and interaction curves, unsupported length, end conditions and long columns; cracking in plastic and hardened concrete and crack-width control; moment-curvature, deflection control and deflection of simply supported beams.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Flanged sections
    • Columns with uniaxial and biaxial bending
    • Introduction to long columns
    • Serviceability checks for deflection and cracking
  4. Unit 4: Water Tanks and Prestressed Concrete

    10 hours

    Circular tanks with a roof slab or dome and rectangular tanks with a one-way roof slab resting on ground by the IS code working stress method; high-grade materials, the concept and methods of prestressing, losses, the Freyssinet, Magnel-Blaton and Gifford-Udall systems and analysis of rectangular, T and I sections.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Circular and rectangular tanks on ground
    • Principles of prestressed concrete
    • Prestressing systems and anchorages
    • Losses in prestress
    • Stress analysis of prestressed members
  5. Unit 5: Slabs, Footings and Staircases

    7 hours

    One-way simply supported, cantilever and continuous slabs and beams with IS coefficients; rectangular pad and sloped footings under axial load; dog-legged and open-well staircases.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • One-way slabs
    • Cantilever and continuous slabs
    • Continuous beams by IS code coefficients
    • Isolated footings
    • Dog-legged staircase
    • Open-well staircase

Unit contents are summarised from the official GUG syllabus . AiCanCode.org is not affiliated with Gondwana University, Gadchiroli.