GUG SY E&TC syllabus

GUG · Second Year B.Tech. Electronics and Telecommunication Engineering · NEP 2020

Electronic Devices and Circuits

STPCCETC304 · Semester III · 3 credits · IE 10 + mid-semester 10 + ESE 80

Unit 1 also covers the p-n junction itself (diode equation, transition and diffusion capacitance) and the Zener diode as a voltage regulator; they are in the unit contents but have no notes topic of their own here.

  1. Unit 1: PN Junction Diode

    8 hours

    Formation and biasing of the p-n junction, the diode current equation and V-I characteristics, static and dynamic resistance, transition and diffusion capacitance; half-wave and full-wave rectifiers with C, L, LC and CLC filters; clippers and clampers; the Zener diode as a voltage regulator.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Rectifier and filter circuits: ripple factor, PIV and TUF
    • Diode clippers, clampers and RC wave-shaping circuits
  2. Unit 2: Bipolar Junction Transistors and Field Effect Transistor

    8 hours

    Transistor operation; CB, CE and CC configurations, characteristics and parameters; the transistor as a switch; low-frequency hybrid and hybrid-pi models and the high-frequency hybrid-pi model; FET, MOSFET and UJT structure, operation and V-I characteristics.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • BJT characteristics in CE configuration
    • Hybrid-pi model and CE amplifier analysis
    • JFET characteristics and parameters
    • Enhancement MOSFET: structure and characteristics
    • GTO, TRIAC and UJT
  3. Unit 3: Biasing of BJT and FET

    8 hours

    DC and AC load lines, the stability factor, transistor biasing methods, thermal runaway and bias compensation; FET biasing; single-stage and cascaded transistor amplifiers.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • DC load line, Q-point and BJT biasing
    • JFET amplifiers and biasing
    • MOSFET biasing and the DC load line
    • RC-coupled CE amplifier and its frequency response
  4. Unit 4: Power Amplifier and Feedback Amplifier

    8 hours

    Classes of operation (A, B, AB, C), their power efficiency and linearity; voltage-series, current-series, voltage-shunt and current-shunt feedback and the effect of feedback on gain and bandwidth.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Classification of power amplifiers
    • Transformer-coupled class A amplifier
    • Class B push-pull and complementary symmetry amplifiers
    • Efficiency and power dissipation of power amplifiers
    • Feedback topologies and their effects
    • Voltage-series and current-series feedback amplifiers
  5. Unit 5: Oscillators and Multivibrators

    8 hours

    The Barkhausen criterion; RC oscillators (phase-shift, Wien bridge) and LC oscillators (Hartley, Colpitts, Clapp); astable, monostable and bistable multivibrators; the UJT relaxation oscillator.

    Examined in the 80-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Barkhausen criterion and types of oscillators
    • RC phase-shift oscillator
    • Wien bridge oscillator
    • Hartley and Colpitts oscillators
    • Astable and monostable multivibrators

Unit contents are summarised from the official GUG syllabus . AiCanCode.org is not affiliated with Gondwana University, Gadchiroli.