DBATU TY Mechanical syllabus

DBATU · Third Year B.Tech Mechanical Engineering · NEP 2020

Machine Design I

Semester VI · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

  1. Unit 1: Introduction to Mechanical Design and Design Against Static Loads

    Design phases and considerations; standardisation and preferred numbers; design data books; material selection; axial, bending and torsional stresses; concurrent engineering; cotter and knuckle joints; eccentric loading.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • The machine design process
    • Material selection and factor of safety
    • Cotter and knuckle joints
    • Eccentrically loaded components
  2. Unit 2: Design Against Fluctuating Loads and Theories of Failure

    Stress concentration; endurance limit and notch sensitivity; finite and infinite life and cumulative damage; Soderberg and Goodman diagrams; maximum normal stress, shear stress and distortion energy theories.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Stress concentration
    • Fatigue, S–N curve and endurance limit
    • Soderberg, Goodman and Gerber criteria
    • Finite life and cumulative damage
    • Theories of failure in design
  3. Unit 3: Design of Shafts, Keys and Couplings

    Shafts, spindles and axles designed for strength and rigidity; the ASME code; flat and square keys and splines; muff and flange rigid couplings; bush-pin flexible couplings.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Design of shafts for strength
    • Design of shafts for rigidity and the ASME code
    • Design of keys and splines
    • Design of flange couplings
    • Bushed-pin flexible couplings
  4. Unit 4: Design of Power Screws and Welded Joints

    Thread forms and terminology; lifting and lowering torque; self-locking and efficiency; screw and nut design; compound, differential and ball screws; butt and fillet welds and welds under eccentric load and bending.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Power screw terminology and torque
    • Efficiency and self-locking
    • Differential, compound and ball screws
    • Strength of welded joints
    • Eccentrically loaded welded joints
  5. Unit 5: Design of Mechanical Springs

    Types and materials of springs; helical compression and tension springs, Wahl's factor, end styles and shot peening; torsion springs; multi-leaf springs and nipping.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Design of helical springs
    • Leaf springs and nipping
    • Torsion springs

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).