DBATU TY Mechanical syllabus

DBATU · Third Year B.Tech Mechanical Engineering · NEP 2020

Engineering Tribology

Elective I · Semester V · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

One of the Elective I options.

All notes for this subject
  1. Unit 1: Introduction

    Friction, wear and lubrication and why tribology matters; surface topography and roughness parameters; single and multiple asperity contact.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Tribology and its importance
    • Surface topography and its measurement
    • Contact between rough surfaces
  2. Unit 2: Friction

    Coulomb and Amontons laws; static, rolling and kinetic friction; adhesion, interlocking, ploughing and other theories; asperity deformation models.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Friction: laws and theories
  3. Unit 3: Lubrication

    Types of lubrication; lubricant properties; hydrodynamic lubrication and Reynolds' equation; elastohydrodynamic, mixed and boundary lubrication; additives and solid lubricants.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Lubricants and their properties
    • Mechanism of hydrodynamic lubrication
    • Reynolds' equation
    • Elastohydrodynamic lubrication
    • Boundary and solid lubrication
  4. Unit 4: Wear

    Abrasive, adhesive and fretting wear; pin-on-disc and block-on-ring testing; wear of metals, ceramics and polymers; two- and three-body abrasion and erosion.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Wear: types and mechanisms
    • Wear testing methods
  5. Unit 5: Tribological Design and Bearing Materials

    Wear-rate estimation and the systems approach to tribodesign; reducing wear by material selection and surface engineering; rolling, fluid-film, dry and gas bearings.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Tribological design and surface engineering
    • Gas-lubricated bearings
    • Rolling and fluid-film bearings

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).