DBATU TY Mechanical syllabus

DBATU · Third Year B.Tech Mechanical Engineering · NEP 2020

Automobile Engineering

Elective I · Semester V · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

One of the Elective I options.

All notes for this subject
  1. Unit 1: Introduction

    Vehicle specifications and classification; chassis layout and frames; main components; engine cylinder arrangements; power requirements, tractive effort and performance curves.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Chassis and body structures
    • Power flow layouts
    • Tractive effort and vehicle performance
  2. Unit 2: Steering and Suspension Systems

    Steering principles, linkages, geometry and wheel alignment; power steering; independent suspension, coil and leaf springs; multi-axle suspensions.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Steering gears and power steering
    • Steering geometry and wheel alignment
    • Independent suspension systems
  3. Unit 3: Transmission System

    Clutches; gearboxes and shift mechanisms; overrunning clutch, fluid coupling and torque converter; universal joints and propeller shafts; front, rear and stub axles; differentials; four-wheel drive.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Clutches and fluid flywheel
    • Gearboxes and automatic transmissions
    • Universal and CV joints
    • Final drive and differential
    • Rear axle types
    • Front stub axles
  4. Unit 4: Brakes, Wheels and Tyres

    Mechanical, hydraulic and pneumatic brakes; disc and drum brakes; brake adjustment and power brakes; types of wheels and tyres, tyre construction, wear and wheel balancing.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Hydraulic and air brakes
    • Wheels and tyres
  5. Unit 5: Electrical Systems, Vehicle Testing and Maintenance

    Batteries and charging; starter motors and drives; ignition systems and timing; vehicle testing standards; servicing, overhauling and engine tune-up; emissions and their regulation.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Automotive batteries and charging
    • Starting systems
    • Vehicle testing, maintenance and emission norms

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).