DBATU · Third Year B.Tech Mechanical Engineering · NEP 2020
Applied Thermodynamics
Semester V · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60
Unit 1: Fuels and Combustion
Types of fuel and calorific values; combustion equations for hydrocarbon fuels; minimum and excess air; volumetric to mass analysis; flue gas analysis.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Fuels and calorific value
- Combustion and enthalpy of formation
- Minimum air, excess air and flue gas analysis
Unit 2: Steam Generator
Classification and working of boilers; fire-tube and water-tube boilers; mountings and accessories; draught and chimney height; equivalent evaporation, efficiency, boiler trial and heat balance; waste heat recovery; the IBR.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Classification of boilers and the IBR Act
- Fire-tube and water-tube boilers
- Boiler mountings and accessories
- Boiler draught and chimney height
- Boiler performance: equivalent evaporation and efficiency
Unit 3: Vapour and Gas Power Cycles
The ideal Rankine cycle with reheat and regeneration; specific steam consumption and work ratio; Otto, Diesel, Stirling and Joule–Brayton cycles.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Carnot and Rankine cycles
- Improving Rankine cycle performance
- Otto, Diesel and dual cycles
- Brayton cycle
- Stirling, Ericsson, Lenoir and Atkinson cycles
Unit 4: Steam Nozzles, Condensers and Steam Turbines
Flow of steam through nozzles, critical pressure, friction and supersaturated flow; condensers, their efficiencies and cooling towers; impulse and reaction turbines, compounding, velocity diagrams, work, efficiencies and losses.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Isentropic flow through nozzles
- Steam nozzles: maximum discharge and supersaturated flow
- Steam condensers and cooling towers
- Steam turbines: compounding and velocity diagrams
Unit 5: Reciprocating and Rotary Air Compressors
Reciprocating compressors: indicator diagrams, free air delivery, multistaging, conditions for maximum efficiency and capacity control; Roots blowers, vane and centrifugal compressors and the slip factor.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Reciprocating air compressors and multistaging
- Rotary and centrifugal compressors
Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).