DBATU TY E&TC syllabus

DBATU · Third Year B.Tech Electronics & Telecommunication Engineering · NEP 2020

Analog Communication

26AF1372PC504 · Semester V · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

  1. Unit 1: Introduction to Communication Systems

    7 hours

    Block diagram of a communication system; simplex and duplex; broadcast and point-to-point; need for and classification of modulation; the sampling theorem and pulse analog modulation; TDM and FDM.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Elements and types of communication systems
    • Need for modulation and amplitude modulation
    • Sampling theorem and types of sampling
    • PAM, PWM and PPM
    • TDM and FDM
  2. Unit 2: Amplitude Modulation

    7 hours

    Mathematical analysis of AM; modulation index, spectrum, bandwidth and power; generation using non-linearity; low- and high-level modulation; the balanced modulator; DSB-FC, DSB-SC, SSB-SC, ISB and VSB compared.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • AM spectrum, modulation index and power
    • Generation of AM: low and high-level modulation
    • Balanced modulator
    • DSB-SC modulation
    • SSB and VSB modulation
  3. Unit 3: Angle Modulation

    7 hours

    Mathematical analysis of FM and PM; modulation index; FM spectrum and bandwidth; narrowband and wideband FM; direct and indirect generation; pre-emphasis and de-emphasis; AM, FM and PM compared.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Frequency modulation and modulation index
    • Phase modulation and its relation to FM
    • FM spectrum, Bessel functions and Carson's rule
    • Narrowband and wideband FM
    • FM generation: Armstrong's method
    • Pre-emphasis and de-emphasis
  4. Unit 4: Radio Receivers and Demodulators

    7 hours

    Receiver characteristics: sensitivity, selectivity, fidelity, image frequency and IFRR, tracking and double spotting; TRF and superheterodyne receivers; RF amplifier, local oscillator, mixer, IF amplifier and AGC.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Receiver characteristics: sensitivity, selectivity, fidelity and image rejection
    • TRF and superheterodyne receivers
    • Envelope detection and the AM superheterodyne receiver
    • Automatic gain control
  5. Unit 5: AM and FM Detectors and Noise

    7 hours

    Envelope and practical diode detectors; slope detector, phase discriminator and ratio detector; sources and classification of noise; thermal noise, SNR, noise figure, noise factor and noise temperature.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Practical diode detector
    • Slope and ratio detectors
    • Foster–Seeley discriminator
    • Sources and types of noise
    • Noise calculations and noise figure
    • Noise temperature and Friis formula

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).