DBATU · Third Year B.Tech Electronics & Telecommunication Engineering · NEP 2020
Analog Circuits
26AF1372PC601 · Semester VI · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60
Unit 1: Introduction to Operational Amplifiers
The difference amplifier and ideal op-amp models; negative feedback and the virtual short; simple op-amp circuits; frequency response and Bode plots; feedback topologies for discrete amplifiers; stability by the Barkhausen criterion.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Op-amp block diagram and ideal characteristics
- Difference amplifier, virtual short and negative feedback
- Frequency response of op-amp circuits and Bode plots
- Feedback topologies and their effects
Unit 2: Linear Applications of Operational Amplifiers
Inverting and non-inverting amplifiers; voltage follower; summing, averaging and scaling amplifiers; difference amplifier; integrator and differentiator; instrumentation amplifiers; active filters.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Inverting and non-inverting amplifiers
- Voltage follower, summing and differential amplifiers
- Practical integrator and differentiator
- Instrumentation amplifier
- First and second-order active filters
Unit 3: Non-linear Applications of Operational Amplifiers
Comparators, clippers and clampers; linearisation amplifiers; precision rectifiers; logarithmic amplifiers, multifunction circuits and true-RMS converters.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Comparators and the Schmitt trigger
- Clippers and clampers using op-amps
- Precision half-wave and full-wave rectifiers
- Logarithmic and antilog amplifiers
- True RMS converters
Unit 4: Oscillators
Waveform generation: sinusoidal feedback oscillators; relaxation oscillators; square and triangle generators.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Barkhausen criterion and types of oscillators
- RC phase-shift oscillator
- Wien bridge oscillator
- Square and triangular wave generators
Unit 5: Analog and Digital Interface Circuits
Single-slope, dual-slope, successive-approximation and flash ADCs; weighted-resistor, R-2R ladder and resistor-string DACs; V-F, I-V and V-I converters.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- SAR, flash and dual-slope ADCs
- Single-slope ADC
- Weighted-resistor and R-2R ladder DACs
- V-F, I-V and V-I converters
Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).