DBATU TY Electrical syllabus

DBATU · Third Year B.Tech Electrical Engineering · NEP 2020

Transients in Electrical Power System

26AF1293PE604B · Elective II · Semester VI · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

One of the Elective II options.

All notes for this subject
  1. Unit 1: Introduction and Survey

    7 hours

    Causes and importance of transients; RL transients with sine-wave excitation; double-frequency transients; RLC transients by transforms; types of power-system transients, their effects and role in planning.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Causes and importance of transients
    • RL circuit transients with sinusoidal excitation
    • Double frequency transients
    • Types of power system transients and their effects
  2. Unit 2: Switching Transients

    7 hours

    Switching overvoltages; resistance and load switching and their equivalent circuits; normal and abnormal switching; current suppression and chopping; capacitance switching with single and multiple restrikes; ferroresonance.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Overvoltages from switching transients
    • Resistance and load switching
    • Current suppression and current chopping
    • Capacitance switching and restrikes
    • Ferroresonance
  3. Unit 3: Lightning Transients

    7 hours

    Cloud and charge formation; the lightning discharge and stroke characteristics; a stroke model; good line design, ground wires and tower-footing resistance; lightning–system interaction.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Charge formation in thunderclouds
    • Mechanism and characteristics of lightning strokes
    • Lightning stroke model
    • Ground wires and tower footing resistance
  4. Unit 4: Travelling Waves and Computation of Transients

    7 hours

    Transient response with lumped and distributed parameters; the travelling-wave concept and step response; Bewley's lattice diagram; standing waves and natural frequencies; reflection and refraction.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Transients with lumped and distributed parameters
    • Travelling waves on transmission lines
    • Bewley's lattice diagram
    • Reflection and refraction of travelling waves
    • Standing waves and natural frequencies
  5. Unit 5: Transients in Integrated Power Systems

    7 hours

    Short-line and kilometric faults; voltage distribution in a system; line dropping and load rejection; transients on closing and reclosing; fault-induced overvoltages and switching surges; EMTP for transient computation.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Short-line and kilometric faults
    • Line dropping and load rejection
    • Overvoltages on closing and reclosing lines
    • Fault-induced overvoltages and switching surges
    • EMTP for transient computation

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).