DBATU · Third Year B.Tech Electrical Engineering · NEP 2020
Power Quality Issue
26AF1293PE605B · Elective III · Semester VI · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60
One of the Elective III options.
Unit 1: Introduction; Voltage Sags and Interruptions
6 hoursClasses of power quality problems; sources of sags and interruptions; estimating sag performance; protection principles; end-user solutions and ride-through economics; motor-starting sags; fault-clearing issues.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Power quality terms as per IEEE 1159
- Voltage sags and interruptions
- Voltage sag mitigation
- Ride-through alternatives and motor starting sags
Unit 2: Transient Overvoltages
6 hoursSources and protection principles; protective devices; utility capacitor-switching transients; lightning protection; ferroresonance; load-switching problems; computer tools for transient analysis.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Transient overvoltages and their control
- Capacitor-switching transients
- Lightning protection of utility systems
- Ferroresonance
Unit 3: Fundamentals of Harmonics
6 hoursHarmonic distortion of voltage and current; harmonics versus transients; quantities under non-sinusoidal conditions; indices; commercial-load sources and locating them; system response; effects; interharmonics.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Harmonic indices and THD
- Power under non-sinusoidal conditions
- Sources of harmonics
- Harmonic resonance
- Effects of harmonics on machines, transformers and cables
- Interharmonics
Unit 4: Long-duration Voltage Variations
6 hoursPrinciples and devices of voltage regulation; utility regulators; capacitors for regulation and at end users; regulating with distributed resources; flicker.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Voltage regulation devices
- Power factor correction with capacitors
- Voltage regulation with distributed resources
- Voltage flicker
Unit 5: Power Quality Monitoring
6 hoursMonitoring considerations; measuring instruments past and present; assessing measurement data; intelligent systems; monitoring standards.
Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then
- Power quality monitoring
- Power quality analysers and EN 50160
- Intelligent systems in power quality monitoring
Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).