DBATU TY Electrical syllabus

DBATU · Third Year B.Tech Electrical Engineering · NEP 2020

Power Electronics

26AF1293PC503 · Semester V · 3 credits · Continuous assessment 20 + mid-semester 20 + end-semester 60

  1. Unit 1: Power Semiconductor Switches

    7 hours

    Ideal and practical switches; static and dynamic behaviour of power diodes, SCRs, power MOSFETs and IGBTs; gate triggering and commutation; optocoupler and pulse-transformer isolation; di/dt and dv/dt snubbers.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Power diodes and power BJTs
    • SCR characteristics and ratings
    • Power MOSFET and IGBT
    • SCR triggering circuits
    • Commutation techniques
    • Gate drivers for MOSFET and IGBT
    • Snubber circuits
  2. Unit 2: Phase-controlled Rectifiers

    7 hours

    Single-phase half-wave, semi-converter and fully controlled bridges with continuous current; THD, power factor and displacement factor; three-phase fully controlled bridges; source inductance and the overlap angle.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Single-phase half-controlled converter
    • Single-phase fully controlled converter
    • Converter performance parameters
    • Three-phase fully controlled converter
    • Effect of source inductance and overlap angle
  3. Unit 3: DC–DC Choppers

    6 hours

    Chopper principle with PWM and current-limit control; classes A to E; continuous-conduction analysis of buck, boost and buck–boost converters with ripple; discontinuous conduction; DC motor drives.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Chopper principle and control techniques
    • Chopper classes A to E
    • Buck converter
    • Boost converter
    • Buck-boost converter
    • Discontinuous conduction mode
    • Chopper-fed DC motor drives
  4. Unit 4: Inverters and Grid Integration

    7 hours

    Single-phase half- and full-bridge inverters; single-pulse, multi-pulse and sinusoidal PWM, unipolar and bipolar switching; three-phase inverters in 180° mode, SPWM and third-harmonic injection; grid-tied single-phase inverters with hysteresis current control.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Single-phase full-bridge inverter
    • PWM techniques
    • Three-phase inverter: 120 and 180 degree modes
    • Third-harmonic injection PWM
    • Grid-tied single-phase inverters and current control
  5. Unit 5: AC–AC Controllers and Cycloconverters

    7 hours

    Phase control and integral-cycle control of single-phase AC voltage regulators with R and RL loads; multi-stage sequence control; single- and three-phase cycloconverters.

    Examined in the 60-mark end-semester paper, and in the mid-semester exam if it is taught by then

    • Single-phase AC voltage controller
    • Integral cycle control
    • Cycloconverters

Unit contents are summarised from the official DBATU syllabus . AiCanCode.org is not affiliated with Dr. Babasaheb Ambedkar Technological University (DBATU).